SailNet Community - View Single Post - Howto drill center of a rail.
View Single Post
Old 03-27-2013
rd1900 rd1900 is offline
Junior Member
Join Date: Feb 2013
Posts: 9
Thanks: 0
Thanked 2 Times in 1 Post
Rep Power: 0
rd1900 is on a distinguished road
Re: Howto drill center of a rail.

Instead of that half-circle groove, make it with two passes on the table saw at 45 degrees. Much faster, easier and will fit the rail better (two lines of contact on the V flanks instead of one line on the curve bottom)

How are you mounting the lights onto the rail now that you have the holes?
Reply With Quote Share with Facebook