SailNet Community - View Single Post - attaching wood furring strips to inside of hull
View Single Post
  #5  
Old 04-09-2013
Faster's Avatar
Faster Faster is offline
Just another Moderator
 
Join Date: Sep 2005
Location: New Westminster, BC
Posts: 15,319
Thanks: 88
Thanked 241 Times in 232 Posts
Rep Power: 10
Faster has a spectacular aura about Faster has a spectacular aura about Faster has a spectacular aura about
Re: attaching wood furring strips to inside of hull

Generally there's some curvature so some way of wedging things in for the cure is usually called for anyway. I used 3M 4200, laid some closed cell foam in the areas between the strips and covered it all with battens. It looks great, flat panels will often be difficult to fit to even a minor compound curve.

It wasn't a large area, but the side of the berth shown below was just a cushion laid against the bare glass originally.

__________________
Ron

1984 Fast/Nicholson 345 "FastForward"

".. there is much you could do at sea with common sense.. and very little you could do without it.."
Capt G E Ericson (from "The Cruel Sea" by Nicholas Monsarrat)

Last edited by Faster; 04-09-2013 at 10:27 PM.
Reply With Quote Share with Facebook