Tartan 27' owner
Join Date: Jan 2008
Thanked 131 Times in 123 Posts
Rep Power: 10
Re: Prop Shaft Coupling
Is that all that is holding your coupling to the shaft? You have no set screw (I would assume you have a key/keyway)?
I have a solid coupling (not split) and yes, there is a set screw which has to be wired so it does not decide to pull out. So my shaft is held in place at the coupling by the press fit and the set screw.
The key/keyway is on the prop end of my shaft.
See if you can torque down the split sides together. It may work.
Obviously I've never used this shop:
Marine Propellers Hawaii
1100 Bishop St, Honolulu, HI 96813
but it would seem near the Alu Wai and perhaps convenient.
"The cure for anything is salt water~ sweat, tears, or the sea." ~Isak Denesen
Everybody has one:
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Last edited by CalebD; 04-24-2013 at 08:51 PM.