SailNet Community - View Single Post - Prop shaft / cutlass bearing overhaul
View Single Post
  #8  
Old 05-22-2013
JimsCAL's Avatar
JimsCAL JimsCAL is offline
Senior Member
 
Join Date: May 2007
Location: Glen Cove, NY
Posts: 2,442
Thanks: 2
Thanked 36 Times in 35 Posts
Rep Power: 8
JimsCAL is on a distinguished road
Re: Prop shaft / cutlass bearing overhaul

You can make a puller easily from a piece of steel plate. Just drill some holes at the spacing of the coupling bolts. Use a socket from a socket wrench set between the plate and the end of the shaft and then tighten the bolts or threaded rods with nuts, pushing the shaft out of the coupling.
Reply With Quote Share with Facebook