SailNet Community - View Single Post - Screw on the mast, Mast Steps
View Single Post
  #10  
Old 06-06-2013
SVTatia SVTatia is offline
Senior Member
 
Join Date: May 2007
Location: Toronto, Canada
Posts: 280
Thanks: 0
Thanked 14 Times in 14 Posts
Rep Power: 8
SVTatia is on a distinguished road
Re: Screw on the mast, Mast Steps

Quote:
Originally Posted by PorFin View Post
Rik,

I just realized that the steps you are citing are composite -- ours are aluminum. So not the same, but of a similar design. Disregard the earlier nylon washer advice
The mast vibrates quite a bit under some circumstances, wouldn't those folded aluminum steps cause a lot of noise?
Reply With Quote Share with Facebook