SailNet Community - View Single Post - Should a Roller Furler be Hard?
View Single Post
  #14  
Old 07-08-2013
JimsCAL's Avatar
JimsCAL JimsCAL is offline
Senior Member
 
Join Date: May 2007
Location: Glen Cove, NY
Posts: 2,363
Thanks: 1
Thanked 31 Times in 30 Posts
Rep Power: 8
JimsCAL is on a distinguished road
Re: Should a Roller Furler be Hard?

Quote:
Originally Posted by T37Chef View Post
My bad, one of the primary reasons I selected Harken was no need to lube it, just spray once and a while with fresh water. I just assumed all Harkens, older models even, were the same.
This link to the instructions for the MK4 unit has lubrication instructions on page 31. Not too different than those for my MK2 unit except mine suggest using WD40. I suspect McLube wasn't available then.

http://www.harken.com/uploadedfiles/...t/PDF/4416.pdf
Reply With Quote Share with Facebook