SailNet Community - View Single Post - Removing pawls and main gear on barient winch
View Single Post
  #1  
Old 08-13-2013
abrahamx abrahamx is offline
Senior Member
 
Join Date: Apr 2006
Location: Michigan
Posts: 614
Thanks: 33
Thanked 4 Times in 4 Posts
Rep Power: 9
abrahamx is on a distinguished road
Removing pawls and main gear on barient winch

The directions may as well say " take all the parts off" When it comes to taking apart the pawls the directions on my tear down instruction sheet mearly says
"Remove four pawls (#20), four pawl springs (#18), and four plung ers (#19) from low range gear". I am not sure how exactally. Is it just a pressed shaft that needs to be hammered out. The main gear has a washer and a pin holding it in. Not sure if its a allen set screw or a pressed pin or what. I just dont want to start tearing stuff down without knowing the proper technique and how to put it back together. They appear to be pressed fittings that would be impossible to get back on if I were to get it apart. Unless I should be focusing on taking it off from the top of the winch. Barient 20 winch. any help appreciated.
Reply With Quote Share with Facebook