SailNet Community - View Single Post - Gennaker downhaul on CS27
View Single Post
Old 08-27-2013
PaulinVictoria's Avatar
PaulinVictoria PaulinVictoria is offline
Remember you're a womble
Join Date: Aug 2009
Location: Sidney, BC
Posts: 2,062
Thanks: 10
Thanked 53 Times in 51 Posts
Rep Power: 6
PaulinVictoria is on a distinguished road
Re: Gennaker downhaul on CS27

Gotcha, so I'd maybe just put a shackle through one of the holes in the furler fitting and get an amsteel strap that reaches just above the furler, and then have a block on the end of that. Then run a line from the tack, through the block and back to wherever you want to adjust it from. The ATN should take most of the strain, the strap/block etc should just allow you to then adjust the height. That's going to be the easiest and is likely to be plenty good enough, I've seen setups where they just had a twisted line between the uprights on the pulpit and that worked OK.
Orange Crush
1974 C&C27 MkII

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Reply With Quote Share with Facebook
The Following User Says Thank You to PaulinVictoria For This Useful Post:
cghubbell (08-28-2013)