SailNet Community - View Single Post - Home made exhaust riser - mixing elbow
View Single Post
  #3  
Old 09-18-2013
JimsCAL's Avatar
JimsCAL JimsCAL is offline
Senior Member
 
Join Date: May 2007
Location: Glen Cove, NY
Posts: 2,363
Thanks: 1
Thanked 31 Times in 30 Posts
Rep Power: 8
JimsCAL is on a distinguished road
Re: Home made exhaust riser - mixing elbow

The Universal 5411 on my previous boat came with an exhaust loop made out of standard pipe fittings. When it came time for replacement, a trip to Home Depot resulted in all the black iron pieces (elbows, nipples, tee, etc) needed. Total cost about $30.

I replaced the U-type exhaust elbow on my current Yanmar 3GM30F this spring. Cost from the local dealer was about $150. Not terrible. If that's what's on your engine, that's how I would go.
Reply With Quote Share with Facebook