SailNet Community - View Single Post - Can Be a Big Job - Support Board
View Single Post
  #8  
Old 05-20-2007
DeepFrz DeepFrz is offline
Member
 
Join Date: May 2006
Posts: 80
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
DeepFrz is an unknown quantity at this point
I don't see any reason that you couldn't cut out the rotted area and scarf in a piece of wood to replace the area cut out. If I were doing it I would sand everything back to good wood and then coat the wood with several coats of epoxy resin, perhaps even adding several layers of fiberglass cloth to the top. Make sure there is no rot back where the shelf joins the bulkhead.
Reply With Quote Share with Facebook