SailNet Community - View Single Post - Fricking Project Headache #2982B: GPS mount in Pedestal Guard
View Single Post
  #4  
Old 06-06-2007
stevemac00 stevemac00 is offline
Senior Member
 
Join Date: Feb 2007
Posts: 176
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 8
stevemac00 is on a distinguished road
Usually not a good idea to cut sounder transducer wire unless it's outputting NMEA (simple serial line). Check with Garmin if it's ok to cut transducer line. If not, in a previous boat I was able to run a RADAR wire up the pedestal using the pedestal hole at bottom. The connector was rectangular so I was able to cut off the boot and bring the connector out at an angle. Get a dremel to grind the sharp edges. Just wrap the wire good at the exit point.
Reply With Quote Share with Facebook