SailNet Community - View Single Post - Fiberglass Bow Tip Repair
View Single Post
  #1  
Old 07-02-2014
ranger22owner ranger22owner is offline
ranger22owner
 
Join Date: Feb 2012
Posts: 15
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
ranger22owner is on a distinguished road
Fiberglass Bow Tip Repair

Hello,

Earlier today I made the huge mistake of hitting the pillar of my dock at the marina. Yes, it was an operator error, yes it was very windy, and I take full responsibility over what I did and will definitely take this as a huge lesson learned .

However, I have a question on how to go about the repairs. My pulpit is toast for it has bent back. The tip of the bow that the base of the middle fork of the pulpit was ripped off because of the sheer force. Thankfully no screws were ripped out of the deck. The place where the fiberglass broke off was on the outer part of the boat so there are no holes/leaks exposed to the cabin.

I would really prefer to do the repairs myself. Any suggestions on how to go about doing them? I have a friend who has done fiberglass repairs before on a hull. Also, an estimated cost would be great to. Please do not criticize for I know my mistake and am definitely embarrassed enough, just any repair advice would be extremely helpful.
Attached Images
File Type: jpg photo 1.jpg (32.0 KB, 91 views)
File Type: jpg photo 2.jpg (50.4 KB, 78 views)
File Type: jpg photo 3.jpg (58.6 KB, 79 views)
File Type: jpg photo 4.jpg (44.9 KB, 79 views)
Reply With Quote Share with Facebook