SailNet Community - View Single Post - Replacing filling caps on deck
View Single Post
post #8 of Old 11-19-2007 Thread Starter
SY Valkyrja
ohaavik's Avatar
Join Date: Sep 2007
Location: Singapore
Posts: 29
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
And there I was thinking I was a natural deck filler changer I best remove it and get the 3M 4200 so I can take care of the last knuckle. There is what appears to be a tiny hairline crack in the non-skid stretching from one of the screws and about 10mm inboard...should i bore this out and do an epoxy fill job while I'm at it?

I read that 4200 forms a permanent bond - will I be able to change the cap in the future if I have to convert back to holding tank? No facilities for pumping out here in South-East Asia but in case I wanted to head for Australia or something it might be an issue that I don't have a tank...

Thanks again for the advice SD, it's very much appreciated.

Last edited by ohaavik; 11-19-2007 at 09:08 PM.
ohaavik is offline  
Quote Share with Facebook
For the best viewing experience please update your browser to Google Chrome