SailNet Community - View Single Post - Cutting floor board?
View Single Post
  #7  
Old 01-06-2008
jgmartis's Avatar
jgmartis jgmartis is offline
Lake Arthur & Lake Erie
 
Join Date: Nov 2007
Location: Pittsburgh
Posts: 110
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 7
jgmartis is on a distinguished road
halekai36 is right

But if the cuts you need to make are all straight cuts use the method shown in this video
http://experttooltips.com/printer_Ho...ne_Video.shtml

Dont forget that the cut will remove wood the width of the outside measurement of two consecutive teeth. This will leave a crack that may not be acceptable to you.

Jim
Reply With Quote Share with Facebook