SailNet Community - View Single Post - Yanmar PTO v-pulley
View Single Post
post #2 of Old 01-15-2008
BarryL
Senior Member
 
BarryL's Avatar
 
Join Date: Aug 2003
Location: Long Island, NY
Posts: 1,826
Thanks: 4
Thanked 51 Times in 46 Posts
Rep Power: 13
 
Hello,

To remove things that don't want to be removed, I have had good luck with heat, cold, and liquid wrench type things. If it were my motor, I would:
- spray liquid wrench liberally around the shaft
- wait 10-15 minutes
- apply heat from a propane torch to the pulley (1 minute or so) (try not to get the shaft too hot, you don't want to put a lot of heat into the engine where you could damage seals)
- wait 10-15 minutes for it to cool
- try and remove the pulley with gentle taps from a hammer on a block of wood, pry bar, etc.

Can't help you with a replacement.

Barry

Barry Lenoble
Deep Blue C, 2002 C&C 110
Mt. Sinai, NY

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
BarryL is offline  
Quote Share with Facebook
 
 
For the best viewing experience please update your browser to Google Chrome