SailNet Community - View Single Post - Bottom Repairs
Thread: Bottom Repairs
View Single Post
Old 06-01-2008
T37Chef's Avatar
T37Chef T37Chef is offline
Senior Member
Join Date: Oct 2006
Posts: 4,442
Thanks: 74
Thanked 41 Times in 36 Posts
Rep Power: 9
T37Chef will become famous soon enough
Post Some tips...

The spring after we purchased our boat, there was a lot of paint build up and was flaking off, etc. So I had the bottom blasted only to find these... Mostly little blisters, not deep, with the exception of about 10 that I ground out.

Here I am sanding ALL the remaining bottom paint off...wear proper safety protection!!!

Still going...all day long...

After sanding down to white gelcoat, I washed it about once a week for about 4 weeks to remove bad stuff, acids, reisdues, etc. then let it dry for another 6 weeks or so

Then I started to fill and fair the bottom. I used West System with filler which has the brown color you see below. I also tried a vinylester product (forgetting the name at the moment) which you see in blue.

Remember...epoxy over the vinylester okay, but not the other way around

more filling & fairing...

Finally...the barrier coat application (gray)...starting to see progress, I put 5 coats on the hull with 3 more or 8 total on the bottom and forward part of the keel & rudder...

Before the last coat of barrier coat cured, about 3 hours in 90 degree Maryland weather, I applied the first coat of bottom paint. Doing this should help form a good bond between the two. I used an ablative paint in black, of which I applied two coats.

Here I start to apply the third bottom paint coat, but in blue, so I can see when its time to re-coat...

Finally done painting...yea right...

Here you can see where I removed the PO's try at a boot strip, I just took the bottom paint up another 1 1/2"...

Finally this spring I painted a new boot stripe... I need to do some repairs to the stripe due to the sling when we splashed her but I'm pretty happy overall.

Its been three years now since I have barrier coated the bottom, leaving the boat in year round. This spring there were no signs of blistering.

Total cost to blast, sand (ended up renting a sander from the yard), fillers, barrier coat and three coats of paint, if I remember correctly was just over $2000.00 and about 60 hours of time give or take.

Good luck, theres lot here that you can search for on the topic...

Shawn & the crew of S/V Windgeist

1982 Tartan 37 CB - Hull #358

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.

Last edited by T37Chef; 04-01-2009 at 10:26 PM.
Reply With Quote Share with Facebook