SailNet Community - View Single Post - Sealing the inside of mast
View Single Post
  #9  
Old 09-23-2008
wstigg wstigg is offline
Junior Member
 
Join Date: Sep 2008
Posts: 3
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
wstigg is on a distinguished road
To knothead Steve -

Hi Steve - Heaps o thanks for getting back to me re: sealing the inside of my Selden spar. The mast came with a fitted foam chunk about deck level but I had to remove it to install an inside headstay fitting that needed to go up the inside of the mast. This block may have been dam. Nuts. Next time I pull the rig, I'll follow your proceedure. Until then, I'll seal the very foot of the mast from the outside and drill a small drain hole and hose to drain down into a catch bucket. This should do just fine. Many thanks again
!
Reply With Quote Share with Facebook