SailNet Community - View Single Post - Reinforcing a tiller?
View Single Post
  #5  
Old 04-26-2009
Stu01 Stu01 is offline
Member
 
Join Date: Feb 2008
Posts: 30
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
Stu01 is on a distinguished road
I had made a couple of tillers out of 1/4" strips and epoxied against a profile that I had made. The second one delaminated along the most curved part because I had too much clamp pressure and squeezed out too much epoxy. So what I did was take a small gouge and dig out small gouges in between the stips. I re-epoxied and it is holding up fine.
Stu
Reply With Quote Share with Facebook