Yes, the NMEA IN + wire from the VHF should connect to one pin (3 IIRC) and the NMEA OUT + wire from the VHF should connect to pin 2. The NMEA IN - and OUT - wires should connect to Pin 5.
Originally Posted by macsailor
I also have my old Map76, it has a cable with an small connector on the end, DB9 (?). What you are saying is this cable should plug into the the Map76Cx and provide the signal required for the VHF.
It is too bad someone does not produce a GPS puck for this application, it could sit near the VHF and be a dedicated GPS just for this purpose.
thanks again, Bob
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
You know what the first rule of sailing is? ...Love. You can learn all the math in the 'verse, but you take
a boat to the sea you don't love, she'll shake you off just as sure as the turning of the worlds. Love keeps
her going when she oughta fall down, tells you she's hurting 'fore she keens. Makes her a home.
—Cpt. Mal Reynolds, Serenity (edited)
If you're new to the Sailnet Forums... please read this To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Still—DON'T READ THAT POST AGAIN.