SailNet Community - View Single Post - removing a thru-hull, any advice?
View Single Post
post #6 of Old 12-03-2009
Junior Member
Join Date: Apr 2008
Location: Rhode Island
Posts: 5
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
If the through hull is bronze, it is soft enough to use a hammer and chisel to cut from the OD of the flange (outside the hull) to the ID. Sounds scary but it works quickly and easily. Bend up the tabs that you create after a few of these cuts and you can push the entire assembly, through hull, seacock, etc. into the hull. Fill hole as shown.
NdN is offline  
Quote Share with Facebook
For the best viewing experience please update your browser to Google Chrome