SailNet Community - View Single Post - How to make a 1/2 through hole a 1 1/2 through hole?
View Single Post
  #4  
Old 03-09-2010
poopdeckpappy's Avatar
poopdeckpappy poopdeckpappy is offline
Senior Member
 
Join Date: Jul 2006
Location: San Diego
Posts: 5,820
Thanks: 25
Thanked 40 Times in 34 Posts
Rep Power: 10
poopdeckpappy has a spectacular aura about poopdeckpappy has a spectacular aura about
Quote:
Maybe put a small piece of plywood over hole and fasten with screws then use hole saw?
I would try this

Quote:
Which side to drill from so it does not wreck the gelcoat?
from outside in just enough to start the new hole, then remove the ply backer and finish it off
__________________
1978 Tayana 37

Freedom comes when youíre ready to sail away. True freedom comes when you donít have to return


Cut off from the land that bore us, betrayed by the land we find, where the brightest have gone before us and the dullest remain behind, .......but stand to your glasses, steady,.......tis all we have left to prize, raise a cup to the dead already, hurrah for the next that dies
Reply With Quote Share with Facebook