SailNet Community - View Single Post - Teak enclosure - latch recommendations needed
View Single Post
  #4  
Old 03-18-2010
bljones's Avatar
bljones bljones is offline
Senior Member
 
Join Date: Oct 2008
Location: South Coast Ontario
Posts: 8,202
Thanks: 33
Thanked 74 Times in 67 Posts
Rep Power: 8
bljones has a spectacular aura about bljones has a spectacular aura about
http://www.leevalley.com/hardware/pa...,52800&p=40361


If you want a really clean look, you could avoid fasteners altogether and rout a rabbet in the bottom of the carcass for the face plate to rest in, held in by a full width cleat on the top of the carcass. make the face plate shorter than the overall height of the carcass, drill a finger hole to allow the face plate to be lifted up to clear the rabbet, then pulled down and out to clear the cleat at the top.
Reply With Quote Share with Facebook