SailNet Community - View Single Post - Crimping versus Soldering
View Single Post
Old 06-16-2010
knothead knothead is offline
Senior Member
Join Date: Apr 2003
Posts: 4,192
Thanks: 50
Thanked 38 Times in 37 Posts
Rep Power: 15
knothead has a spectacular aura about knothead has a spectacular aura about knothead has a spectacular aura about
Originally Posted by ulferlingsson View Post
This thread is a little bit odd because it does not discuss when, where, why. I mean, it is like asking, "Is it better to weld or to use bolts?" It depends, doesn't it?

Soldering is excellent for small things, light things, and if done in a well controlled manner. Most bad soldering joints are probably the result of working with inferior equipment, in the field, and without proper training. Dirty connectors, cold solder, etc.

For heavy gauge wire, soldering should not be used. For AWG 20 or finer, with a temperature controlled iron, it is excellent - if heat shrink tubing is applied well outside the joint on both sides, for strain relief. Or use two layers, it's not that expensive!

My God Man!! Do you have any idea what you've just done?
Reply With Quote Share with Facebook