SailNet Community - View Single Post - Mast Step Plate
Thread: Mast Step Plate
View Single Post
  #5  
Old 12-10-2010
mike dryver mike dryver is offline
Senior Member
 
Join Date: May 2006
Posts: 247
Thanks: 0
Thanked 1 Time in 1 Post
Rep Power: 9
mike dryver is on a distinguished road
Sailingweb if the heads of the screws fit properly then they are the right size. just pull one if you have not already done so and check shank diam to hole diam. a mast step is in compression load not shear load unless a stay or shroud fails
Reply With Quote Share with Facebook