Not Finished Yet
Join Date: Jun 2009
Thanked 51 Times in 46 Posts
Rep Power: 8
RainDog - I'm wondering where you drive the shim. It is least tight for and aft but I still do not have a gap. I played with a screw driver but saw that was going to become a ding and I quit.
I used something similar to this: Craftsman 13-1/2 in. Pry Bar Reviews - Craftsman Community
and force it between the two boards. The goal is just to push them apart so there is a small gap between the two floor boards.
After I am done with this, I stick a 2 foot screwdriver through the finger hold and use it as a lever to lift the board.
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Last edited by RainDog; 06-28-2011 at 10:22 AM.