SailNet Community - View Single Post - Cal 21 Keel
Thread: Cal 21 Keel
View Single Post
  #39  
Old 08-08-2011
sailnova's Avatar
sailnova sailnova is offline
Member
 
Join Date: Jun 2010
Posts: 42
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
sailnova is on a distinguished road
It is 3/16in so it is a bit small. In the keel re-build process we ended up putting some filler that was then drilled out over the locking hole...From a thread on the cal 21 site I read someone using a 1/4in brass. Apparently the original is 1/2in. It's easier to make the hole in the trunk bigger rather than smaller which we plan on doing. Rippy, is the pin you have 1/2in?
Reply With Quote Share with Facebook