SailNet Community - View Single Post - Bill Shaw Design Drawings
View Single Post
  #5  
Old 09-21-2011
norsearayder norsearayder is offline
Senior Member
 
Join Date: Dec 2006
Posts: 286
Thanks: 3
Thanked 3 Times in 3 Posts
Rep Power: 8
norsearayder is on a distinguished road
at the end of 2010 i thought my steering [on p-32 s/v magic] was a little rolly going back and forth. 0n hauling .....there was 3 flat head screws holding the shoe on the underside[scrape off bottom paint underneath shoe &acess screws by swinging rudder all the way port or starboard] it turned out that tthe rear screw[3/8]was sheared completely off...this spring i rebored the old hole and installed 1/2 inch bolt......as for the rudder i would have the stainless steel web rebuilt and then make my own rudder sanwithched over...not too hard a job when u get into it..good luck
Reply With Quote Share with Facebook