SailNet Community - View Single Post - S2 11.0 Spar Supplier?
View Single Post
  #1  
Old 10-17-2011
patrscoe's Avatar
patrscoe patrscoe is offline
Senior Member
 
Join Date: May 2011
Location: Richmond, VA
Posts: 241
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 4
patrscoe is on a distinguished road
S2 11.0 Spar Supplier?

After looking through a old sailing log, I found out that in 1989, the first owner of our recently purchased 84' S2 11 cut the mast down by 30" due to a near by bridge. It was disclosed to me and I never notice the difference and perhaps just leaving it alone would save a lot of money and time that I could put some where else but now that I do know, it is driving me crazy.

It appears that they cut the top of the mast as the lower shrouds have not been modified along with the boom attachment and mainsail track.

I want to look into providing a 30" splice at the bottom, modify the spreader and lower shroud locations (move them down 30"), modify my roller furling, alter my sails and replace the upper shrouds. I know this procedure can be done successfully and what would save more time if this could be done towards the top of the mast but I am afraid of failure and I would never be able to see it.

Does anyone know a spar supplier that has the mast profile for the S2 11.0?
I'm in the process of contacting Rig Rite.

Has anyone removed the mast and have already taken measurements of shroud and spreader locations? I don't want to completely assume that they do not modify these locations so I want to double check the measurements.


Thanks!
__________________
Patrick

S2 11.0A 36'
Kinsale, Va
Tanzer 16'
Moseley, Va
Reply With Quote Share with Facebook