SailNet Community - View Single Post - cutlass bearing
Thread: cutlass bearing
View Single Post
  #13  
Old 09-24-2012
Kutter Kutter is offline
Member
 
Join Date: Dec 2006
Location: Devon
Posts: 31
Thanks: 0
Thanked 1 Time in 1 Post
Rep Power: 0
Kutter is on a distinguished road
Re: cutlass bearing

Quote:
Originally Posted by Gene T View Post
Some comments on cutless replacement. It can be done without removal of the shaft by using a proper puller.

Gene
If it is a more modern bearing bedded on epoxy this will have been a low temperature epoxy which will soften around 70-100C, it can then be slid out as it is not an interference fit, no press or puller required.
Reply With Quote Share with Facebook