- Bimini replacement ideas and opinions
- choke setting
- Solar shower reccomendation?
- Jib/genoa lines
- Considering going to golf cart batteries
- Briggs and Stratton 5 HP Help
- New England Autohelm ST4000 repair?
- drop top dodger
- Intermittent Depth Sounder
- Chart Swap?
- swing keel housing hole/delamination
- Fishing Rod/Reel
- Normal prop noise?
- Jeanneau 36i Owners - Need some help!
- Opinions on Rocna Anchors requested
- Clutch slip?
- Hairline crack on mast
- Anyone know how to remove this shower drain?
- Restoring a Snark
- Bonding aluminum to polycarbonate: primer?
- Checking transmission oil level Yanmar 2GM
- Wiring question - Echo Charger and Batt Monitor
- Almost didn't do a stupid thing
- Head...How does this thing work?
- Head...How does this thing work?
- Block Shiv Repair
- Echo Charge vs. battery maintainer
- Two questions
- Block Island 40 Autopilot
- Fixing up an old Catamaran
- trying to remove a spinning coupler bolt
- Need Expert Advice 02
- Nylon sail slides / slugs
- Changing instruments
- stainless rust inhibitor
- ecofriendly bug repellant
- Stupid Rigging Question
- vacuum for boat
- hand held brass fog horn
- Topside paint coming off in sheets
- Extra-thick cabin top?
- Chain problems
- Insect repellent melts foam rubber and plastic. Yikes!
- Insect repellent melts foam rubber and plastic. Yikes!
- Turnbuckles: difference between jaw and fork
- CS-36M keel saga update
- V Berth Bedding alternatives
- Pearson 26 Jib sheet lead.
- Wanted! Old Sails-SF Bay Area
- need a good diesel machine shop
- Catalina 27 Bulkhead
- The restoration of Windsong
- fire extinguisher
- Bridle and Vang Setup
- Furling line fairleads vs. blocks
- auto pilot drive belt
- Jabsco Course Mesh Pumpgard Issue
- Wind generator and refridge question
- Covering hatch holes when repainting.
- 6hp evinrude
- Figuring out a backstay adjuster on a C&C Mk2
- Splicing Double-braid
- Solar panel mount fabrication
- Look at this gelcoat condition, please
- Whay do so many people still choose red night lighitng?
- lubricate through hulls
- best old self tailing winch
- Bent Rudder Shaft
- Need sanity check on heterogenous house bank configuration
- I NEED EXPERT ADVICE on wooden sailing boat!
- Looking for Catalina 22 main sail
- Small outboard charging systems. (Tohatsu/Nissan in specific.)
- Wench of a Winch
- Harken Traveller on a C&C 32
- CSI CNG Stove to LPG
- help! Rough running engine
- sealing threads on fuel filter
- How to install hardware on cabin top when I can't access the underside?
- Chrysler Mutineer Bailer?
- Alexseal - any experiences??
- portable sewing machine
- I believe this is how my tranny works
- Main Traveler backing
- Dry Bags
- Ranger 28 work
- Arrival of the Lady J. She comes to Baggett and Son's for a makeover...
- Rule "fully automatic" pump is not...
- pressurized h20
- Raymarine X-5 Help
- Refrigeration conversion
- Vinyl Lettering Removal from Awlgrip
- Ignition switch corrosion
- Inflatable delaminated
- Dinghy: to plane or not to plane....
- seafarer 24 project
- propeller brake ?
- halyards down the inside of the mast...
- Troubleshooting Charging
- Self Tailing upgrade Winchmate V.S. Hutton-Arco
- spreader bars one set to many?
- wierd winch placement
- teak
- Leaking Vented Loop
- engine cleaner
- Diesel addatives
- sewage backs up into head when boat heeled
- Starter just 'clicks' until I bang on it
- furler recommendation
- S-2 6.9 Grandslam mast needed
- Bright-work refinish with Honey Teak, advice?
- Stinky Hot Water from Tap
- Propane on stern rail - doing it right.
- Charging Light Question
- Victron BMV 600 - Issues Installing
- dinghy outboard intermittent no start
- black under bottom pait
- Cutlass Bearing and rudder bearing
- short haul bottom cleaning
- Cable slap within mast
- Reference book for repairs/modifications
- Propane locker for CNG conversion
- iPad - my new boat computer
- Help Removing Broken Bit
- wheel for sale or trade
- The best fabric for awnings and dinghy cove and apron?
- uniden voyager
- Nav lights LED replacement?
- build up in holding tank
- Some DIY A/C.
- Woodwork.
- Bayfield 23 Standing Rigging Tensions
- Painting a fiberglass hull ?
- Alarm sound volume
- Is it time to paint?
- halyard slap
- Dissatisfaction with Jabsco Pumps
- Reducing the number of through-hulls
- Leak in the hull
- delamination, fix the deck
- Throttle Cable
- Yanmar Key Switch problem
- Maxsea and USB GPS troubles
- pump out problem
- Harken Rollerfurler troubles
- Life raft
- older Nicro solar vent mounting question
- Teak.... again
- Smoking fiberglass
- groco pressure tank installation
- Fourwinds trailing generator
- Main lies closer to wind than jib
- Sort of looks like self tailer
- winch trouble
- Looking for Custom Sliding Hatch Manufacturer in USA
- Keel saga, for those contemplating this procedure for your boat...
- Pump problem or ??
- EPIRB- with or without GPS, Manual or automatic release
- Makeshift Shifter
- AIS / VHF combo
- how will the extra lb affect sailing?
- Broken cap for depth sounder sensor
- Brighten my brights
- Siphon Loop
- Building a keel stand.
- for the experienced ballast ratio??
- Galley Sole Replacement
- Anti Bird Spikes for Spreaders?
- Zincs in heat exchangers
- Leaking hull/keel joint
- Replacing bulkhead bolted chainplates with deck bolted with a wire strut
- Looking for Cat 30 TR mast
- Tank cleanout
- Pulsing kerosene stove
- Broken shaft....and what else?
- Anchoring always a deliberat action or...
- Raccoons
- Plexiglass hatch question
- Winch ID
- Dinghy Floor
- Irwin 39 restoration.
- You think your Refrig is old?
- Affordable Dinghy Cover
- What's the best way to ship a 200 pound anchor - WI to NY?
- anquering question?
- a4 question
- I need a whipping
- cockpit lockers...need advice!
- Damn electrical Panel Keeps Dieing
- Screeching wheel
- Wooden mast repair
- How to Point Better
- Depth meter
- DIY sliding outboard mount
- Pressure Water, Black Grit
- Cheap boom gallows
- Anybody ever use SEADEK?
- Insulate Ice box on Apache 37
- Jeanneau SO 50DS with exposed electric cables at foot of mast
- Hot Water Heater what size/type?
- New reef point, unexpected problem
- Old style CDI furlers
- jib furler selection
- UV resistance in sealants
- I like these, do I really need them?
- Need Help, looking for a Caretaker
- Repair Or Replace Your 12 Volt Refrigeration?
- Oil in Heat Exchanger
- Cheap (kinda) supplied air sanding hood
- Mainsail shape
- Standing Rigging, DIY or pay a Professional?
- 16' hulls
- central heating systems and installation
- Sandblasting vs. Soda blasting
- A stupid snubber question?
- Sometimes you just get lucky! used sails
- lifelines, why so strong?
- converting raw water head to fresh water
- Work-Boat Pulleys source
- Maint. charger for deep cycle
- NMEA 2000 or NMEA 0183
- Year-round in freshwater, best bottom paint to last several years?
- alcohol stove questions
- Advice for Rebedding and Aluminium Toerail
- G/Flex, Flexypoxy for Keel Hull Joint?
- Reefing setup
- Replacing prop while in the water
- Separating cleaning rebedding hull deck joint
- Help -- Sikaflex: I'm sick of it and it flexes
- Bilge pump that leaves very little water available?
- Catalina 27 Aft Lower Shroud Question
- Reel Winch? Replace 3/16" wire rope halyard?
- Do you cover a wet sail?
- Head/Water System Set up
- Volume of a tank (alcohol)
- The restoration of Lady J, the beginning...
- Help with Deck Gear? What are these?
- Contest sailboats!
- Replace Cutlass Bearing on a Contest 31
- Home-built swing rudder
- Hull deck joint screws or bolts?
- Bulkhead question: Cat27
- Best front sail for 25 foot Catalina?
- "Surfing anchor"
- Lint free roller cover
- Garmin Autopilot for sail
- Ripped Main Sail
- Outboard size for 20ft sailboat
- Radar reflectors
- need sitex sp 80 advice
- Removing numbers from a sail