- Winterization- Use of Winshield washer fluid
- Rebedding aluminum toe rails
- Anyone know the right size line for Furlex 200?
- ice Box Cooling unit
- Holly grail for new teak!
- Help with seperating windlass from deck
- How Much For A Cockpit Enclosure?
- Meissner 21 Parts Help
- Electronic Barometers/Barographs?
- Dissecting a Windlass
- Looking for an interior craftsman in the Seattle area.
- CORE Moisture Evaluation - How should I Fix the Issue
- How to buy a sail?
- My kingdom for a good bilge pump and an honest manufacturer!
- Halyard Shackles
- Which goop for bedding
- Mast Down or Up for New Wind Instr.
- Important question about bottom of my sailboat
- NeilPryde Sails
- Deck Grizzly grip non skid paint ..don't waste a nickel it's a fraud
- PSS Dripless Shafts or others?
- 2QM15 Raw Water Pump
- Epoxy or replace bulkheads?
- Changing Fuel Filter- How not to do it
- moody keel studs/bolts
- Operating temp for Perkins 4-108 ????
- Tachometer testing
- Sailing Kit; loves, hates and problems
- Slimed again!
- monel vs stainless how do you tell them apart
- Lead Paint
- Marine oil vs Mobile One Synthetic?
- adhering plywood to fiberglass
- Sails for sale
- propane on demand water heater
- Cutlass bearing question
- weeping keel 1980 30' CB O'Day
- Countertop refitting
- Generator Installation Location
- How does this backstay adjuster work
- Which gen-set do you have?
- C/B & S/K gripe & praise thread!
- difficulty raising mainsail
- need exhaust manifold for my W30
- Through-hulls closed in winter?
- Wooden Cradle Plans
- Bending a bow pulpit to fit
- engine cutoff
- Bottom paint bleed into gel coat?
- Spruce Mast and Roller Furling
- Trying to decide what type of Backstay Adjuster to purchase
- White smoke coming from my Perkins 4108?
- Zinc bonding system on the hull?
- NMEA2000 GPS Receiver question
- Rigging sub heading
- Goose neck separated!
- Portapotty or holding tank on a Tanzer 8.5
- Water in transmission fluuid
- Watermaker Plans
- Gpsmap 640
- what is this attached to teh back stay??
- Compression Post Blues
- Compression Post Blues
- Do I need to buy offshore foulies for this south-bound delivery?
- Noisy, hard start Volvo
- Guzzler Bilge Pump
- propeller calculations
- composting toilet report
- need vendor for sheave, mubir block
- Force 10 large burner cap
- Raymarine X5
- Tips for using new toy
- CT34 - Portlight Seals - Help!
- spot messinger ?, those who own, in here
- Spinnaker Sock
- Older EMS gauges
- Jiffy reefing and attaching things to the boom. Rivets?
- Better hose clamps?
- codensation in half full fuel tank
- Scan Strut Backstay Self Leveling Radar Mount
- bottom paint 101
- need a laugh, dingy failure tonight
- Binoculars (more aptly quadoculars !)
- Greasing Seacocks
- diesel engine Perkings model 4236,max hours
- Condensation Sensation
- Fuel Filter ID?
- need ideas for gravity feed diesel tank
- Anyone Built a wooden cradle?
- Electrical wiring Diagrams
- confused about auto pilots
- FG repair help
- Toyotomi Cabin Heater Problems
- Battery buy Seattle area
- Does this work?
- Fiberglas hull TLC
- Dodger frame with solar panel .045 or .062 thick?
- Help with installing a tiller pilot
- Automotive antifreeze vs. RV antifreeze for engine.
- Freshwater plumbing overhaul
- installing Cal 34 rub rail
- Running rigging wear on boat finish..
- Broken Mast Help Please
- Johnson 7.5 change impeller
- Leaking keel bolts
- Installing new AGM Batteries
- CMAP vs. Bluechart in the Bahamas
- Determining wire polarity
- halyard knot or splice
- Boat rebuild rant.... AAAAAHHHHHHH!!!!!
- Manual for 7.5hp Gamefisher Outboard
- Troubleshooting LPG Control Panel
- Buying Sails
- Wanna-be salt starting electronics troublshooting
- Dye in holding tank
- Slowly but surly
- Do people steal magma grills?
- Stuck Oil Plug - Ugh
- bottom paint problem
- Diesel Fuel Filters
- changing cutlass
- Sanding / painting on a cradle
- Running diesel to Charge Batteries
- issues with Panda genset
- DYI Depth Souder Hull Fairing
- Raymarine s1 autopilot wheel
- "Always up" jib sheet blocks- A low budget idea
- Bent mainsheet shackle (pictures included)
- yamaha engine 9.9hp
- R There Different Air-X 400's?
- Wet/Dry Vacuum
- Oh Joy refit 9/24/09
- Shipmate stove
- Companionway Door Ideas
- Ray jeffeerson VHF RadioTelephone 9100
- Crap Update: Snake Failure
- Greasing a Lofrans Windlass
- used fiberglass boat
- Keel Repair
- How do I tighten a CDN Roller Furling Jib
- Help w/Splice (in Tacoma, WA)
- Replace bulbs in cabin lights with LEDs
- X5 wheel pilot installation????'s
- Filling in a deep bilge
- Haul Out in Kemah/Galveston Bay
- lube oil pressure light
- Good, inexpensive, chart plotter
- Dripless vs Flax Stuffing Boxes
- anchor cuts mooring lines
- West 410 filler & Pettit Protect compatibility
- restoring gelcoat - Need Help
- Rebuilding bronze portlights
- Servo-rudder with tiller autopilot - a good idea?
- Thru Hull Question... Newbie girl here.
- How to rig mainsail for Reefing
- The Transparent Canoe Kayak
- Sailboat Awning - ShadeTree Awning?
- Grinder / sander recommendation?
- Frayed Knot
- Cracks in the Keel Near the Prop
- Radar Necessity
- Hiring / Controlling a Contractor
- Lost Rudder
- Lewmar D1 clutch problem
- rock climbing harness as a sailing harness
- Mounting a Nanostation 2
- transducer cable
- Inflatable Tender (Rubber Duck Inflatables)
- Satellite phone questions:
- Possibly a stripped halyard?
- Spinnaker set-up for a '76 Venture 25
- Dock line requirements
- Marelon and PVC
- Winch covers--are they worth it?
- Who makes a windlass with a 3/8 BBB gypsy??
- redoing decks
- Must have Tools
- Rough day at the boathouse 9/17/09
- Seeking opinions on best diesel repower for long-haul voyaging
- fully extended jackstands
- Refinishing Tartan 30 Cabin sole
- motor problems
- Rigid Vang Selection
- Heat air unit for 36' sail boat
- VHF Radio speaker noise
- Link 20 rewiring
- Need help with balmar 2 output alternator
- Oh Joy refit 9/16/09
- Kenyon Knotmeter/Log
- Fretted internal threads in mast
- Destroyer wheel?
- Navigation Instruments - Pelorus
- how dry is dry?
- StarBoard material?
- Wagner N-40 hydraulig steering ram seal replacement
- Paint choices for trailered sailboat
- Anchor lift Windlass Mako 1500 vertical with capstan Any good?
- Used Genoa question.
- Motor Mounts-1986 Catalina 30
- "Hatch Latch"
- oil extractor
- Holding tank not empty after pump out?
- Backing plate options
- Structural memory
- Deck paint/ epoxy???
- 1 part areosol spray epoxy
- Portlights..
- Spin On Fuel Filter Adaptors
- lewmar hatch hinge caps
- Teak inlaid cockpit seats
- Replaced chain plate deck core - Did I do something stupid?
- MinWax on a boat
- Converting water tank to diesel tank - fittings?
- new railings
- Lewmar, Bomar, Beckson ports...
- CD Player and a Deep Cycle Battery
- Watertight seal on thru-bolt deck hardware???
- New Outboard engine and dingy!
- Gooseneck fitting Capri Cyclone 13
- Propane (Gas) Sensors
- Where Can I get this type of snubber?
- Mercury 2.5 Hp problems
- GPS via cell phones
- Blue Chart MapSource real time tracking
- replacing rear main oil seal universal 5424
- where to find Chrysler !10 hp outboard parts
- extending GPS power and data cables
- Keeping a clear head
- Replacing broken roller furler
- Input on mast/boom hardware required
- Please help me identify this lashing/knot!
- Long Range WiFi -- Posting right now using "long range" wireless
- Request a Proof Read
- Used Sails?
- building a sailing kayak?
- Diesel Exhaust Gas Temperature
- Bottom paint in the Caribbean
- An endorsement of squeeze bulbs
- Sanding anti-fouling
- Help! Dropping mast with roller furling?
- Drifter for light air
- Need advice about audio input from M710 into PC-soundcard
- Autopilot ST4000
- Older C-Map ?'s
- Rent truck for trailoring
- 2nd Alternator
- Suggestions for sailboat cover
- Atomic 4 Exhaust Flange
- Lewmar Winch repair (tightening)
- Liferaft Question