- Teak Oil stained the deck
- Specific Problems to look out for on specfic boats
- antifreeze to preserve wood ?
- New Boat Owner
- Guck, Inc in Bristol, RI
- Hypalon adhesive
- Balmar regulator and combiners
- Laptop-based Chart Plotters
- Home made jack stands
- To What Extent Should I Help?
- Suggestion: Make sure you exercise your deck caps...
- test
- Removable anchor light that clips to railing
- Dead Battery on Catalina 25
- Kevlar Sail Care
- Rudder Replacement
- Xantrex / Prosine Experiences?
- How long does Sunbrella last?
- Universal 5416 / M-20 - Performance Survey
- Changing traveler location?
- Interlux Brightside how to!?!?
- Fuel filter setup
- Traveler advice please...
- Electric drive
- 3.5 hp Tohatsu 2 cycle not pumping water
- Oil in the Keel?
- Propshaft packing question
- How to Clean a dirty bottom
- centerboard specs
- Replacement of Fixed Portlights on a Cal 34
- Single handling Safety and Convenience Mods
- centerboard
- Funky Winches!
- safe unattended heat
- Binoc's - individual v. center focus
- EPIRB Insallation
- 24v - 12v
- foot block (or use cheek..)
- Aluminum painting issues.
- Jabsco Macerator Pump
- BBQ and propane question
- Jabsco macerator pump not pumping just whinning.
- Bleeding a Universal M25
- couloring of Dacron Sails
- Allmand 31 Headliner Replacement
- boat drano
- Boat cleat repair.
- Tracking down a ground fault
- changing cooling from salt to a closed system
- Estimating Time to Restore a Boat
- Roller Furling Foul Up
- Cal 29 keel bolts ?
- mast prep for winter storage
- How to remove fiberglass resin from non-skid deck
- Thumbs up to Dan Fender
- Recommend a Portable AM/FM/etc Radio . . . that's Solid?
- Is a Fibreglass boat built in 1964 at the end of it's life?
- Solar panel on c-way hatch?
- fuel filter priming
- Marine battery group size whats the difference???
- Need help with replacing rotted plywood
- slack in forestay
- Barient 25 upgrade to selftailing Barient 27-48ST
- Barient 25 upgrade to selftailing BArient 27-48ST
- Screwedup my paint job - next step?
- Nasty guest mooring pennants: Idea
- Replacing 20 year old Danforth anchor
- Cockpit drains and check valves
- mixing refrigerant
- Rhino type liner for deck?????
- Teak toe rail repair
- Name that fitting...
- Dutchman system
- Filling a Stanchion?
- 110 Volt Windlass?
- another ? about older Isomat masts.
- Boom Furler
- Garmin Colorado 400c gps opinions?
- Masthead light no workee
- Spot painting a mast with Awlgrip
- Duct Tape Removal
- Types of paint for trailer sailboats
- Heads up - AIS Class B just got cheaper
- Will a yanmar 2QM20 fit in a Catalina30?
- Mechanics of bottom painting
- Squeezed the grease out of my winch
- The helm is a bit heavy!
- Which foam for interior cushions?
- Need a boat yard recommendation for Anacortes, Washington
- Which Bottom Paint?
- Curing a leaky hull to deck joint on a Morgan 461
- Help me...Spock. Leaky question
- Tiller / Rudder Locked Up / Seized
- Old Johnson 6 hp
- (Almost) Lost My Fresh Water Pump Today
- bayfield 29 fuel tank dimensions
- Tip on replacing a seal
- Replacing wire halyard with cord
- WHAM or seperate VHF radio?
- Tiller delaminating, which glue?
- Lavac marine toilet
- rudder/tiller assembly
- Recommendation needed: Diver/bottom cleaning Annapolis area
- Rudder clearance
- Replacement hatch
- Head Smell Solution
- Chrome vs. Aluminum Winches
- R&D (PYI) Motor Mounts for Yanmar
- Yanmar 2GM-F hard start/rough running
- Leaking older Lewmar hatch
- Canvas shop in GTA area
- Plumbing for Greywater in Great Lakes
- standard horizon md50
- Looking for Shipmate 214 Galley Stove
- Lewmar Folding wheel Hub
- Help Me Get Hosed!
- 303 Aerospace protectant on sails?
- Xantrex 2000R discontinued
- Feeding my watermaker
- Depth sounder thru hull compatability
- Need Outboard Mechanic in Oxnard/Ventura area
- Lazy Jacks...yay or nay?
- Anchor rode storage ideas?
- Autohelm AH800 problems
- Lewmar standard portlights good enough?
- Wanted Mast for Beneteau 285
- Interior handholds
- Attention Boaters
- Marine Surveyor Jupiter FL?
- Deck Sealing Question
- Raymarine ST4000 Autohelm binding
- DS 16 sails and parts?
- Forestay Length
- Seagold desalinator
- Avon Liferafts
- Battery Size with the same AH...
- Good fiberglass guy in Baltimore area?
- Off her lines?
- Off her lines?
- EZ-JAX - problem with receiving merchandise
- Small boat furling system questions. Like Harken 435/436
- patch hole in fender
- Replacing Halyards
- Hatch replacement
- Sticky Rudder
- Teak Smells?
- Looking to replace the bilge board/cover
- Bungs
- macgregor 222 rigging
- Whitlock Constellation pedestal
- Nuts!
- galley countertops, new formica or?
- Swage or Himod fittings
- Pulled the sticks and didn't break anything
- Painting my boat
- Replacing Winches
- White gas?
- Com Pac 16 Quick Question
- Anchor light w/photodiode opinions/options, battery draw
- Steering chain jumps sprocket
- Force five Rudder repair
- Painting non skid gelcoat on topsides
- Category I lifejackets for offshore
- Instrument panel came right out
- Replace Main Halyard using a "messenger"
- Yanmar 2GM
- Trailerable/slipped c22 bottom paint?
- How Do you Organize screws?
- Kudos to Kato!
- very stiff rudder and tiller
- Old merc outboard stuck...
- Anyone know where to buy these?
- Manual Windlass- Vetus Ursus vs. Lofrans Royal
- Mold in Crevices on Deck!
- Evaluating a used asym spinnaker
- Dinghy decision
- Control cable replacement
- Dinghy - AQUA MAX HDR 7500
- Fuel pump Questions
- Odd Air Conditioner Installation
- autohelm 4000 parts
- Compass Bubble
- chainplate relocation help! (old ones FIBERGLASSED IN!)
- Windrose keel winch
- Exhaust Hoses
- What size spinnaker for a 30 foot boat?
- Selling Used Sails
- Mainsail Furling
- New Boat 3 questions
- Potable Water Pipe
- Groco SV 1500 seacock
- gas / alcohol stability 4stroke
- Profurl LC 32 (info' please)
- Oil Lubricated dripless shaft log
- Registration numbers on an inflatable
- Dishwasher & washing machine
- spectra and sta-set for spin sheet
- PYI Engine Mounts and PSS
- Anti fouling directly over glass?
- Looking for opinions on UK Halsey sails
- man my mainsheet hylard be all rope?
- dinghy bottom coating results
- upholstery
- Lido 14: Lead shot centerboard
- Dinghy Motor Recommendations
- Looking for a light
- PC on a sailboat
- Gelcoat Cleaning/Restoration
- Dealing with Spiders?
- Boat building schools in Europe
- Travler ball bearings fell out
- Sail Slugs comming out of the slot
- Dual Backstays or Split Backstay
- Novice compounding/waxing question...
- Adler barbour refrigeration conversion
- coastal sailing requirements
- Old Sail Question
- Vibration / Alignment
- Cleaning scuff marks on hull
- barefoot vs sailing shoe alternative
- Nicro Solar Vents dying on me
- A solent stay installation
- Stuffing box adjustments Westerly 26
- Shore charging systems
- Harken bat car system
- Seeking opinions on North 3DL sails
- Dinghy repairs gone awry
- whats the difference between Lewmar Standard and Atlantic opening portlights?
- Injecting epoxy in wet core
- Looking for Autohelm 3000
- water in bilge of small boat
- Screwing in the Bilge
- Carpenter in Annapolis area?
- rigging tension on a Nimble 20
- Male pilot coupling optional for output flange?
- Installing refrig. this weekend - Advice?
- Traveler replacement
- Luna's Restoration
- New guy - sextant question
- Ideas for safe on board heat
- Small portable gas generators
- prop cavitaion issue -- need help
- Too hot to varnish or much anything else..
- Aluminum Sacrificial Anodes for "brackish" water???
- Cigarette smell
- Antifouling clarification
- Achilles inflatables
- Need a Good GPS - Chartplotter - Depth finder - Suggestions!??!!?
- Cheap solar & wind power
- Navico HP5000 (simrad)