- Refinishing Teak
- Problems with Protech1240i
- Modified External Tank for Nissan 3.5
- What to use to grind/sand fiberglass?
- 1932 Hereshoff 34 - reborn
- parts needed sole bay ketch 1977
- Hot water spurting from faucet--causes?
- Where do I find a trailer for a CAL 24?
- Kanzaki km2 service manual
- Help with refrigeration decisions...
- Chain plate metal bad
- Zinc on 1968 McGlasson Islander 34
- Contemplating a drive line overhaul
- Installing a Garmin 7215 Touchscreen
- Suggestions for installing chartplotter on the binnacle
- Fender Hangars
- Outboard Survey
- Who sells quality used aluminum spars in the North Eastern U.S.?
- Rubber Faucet Diffuser
- Sail Repair/Refresh
- Nav program
- Long Vs. short
- Ripped Sail! Can this Sail be fixed?????
- Lewmar Winch Repair
- Dacron Nylon Polyolefin
- Recommendation for a Portable Head
- Toe Rail Replacement: Teak or Mahogany
- Will Oxalic Acid Damage Brass HE?
- Barnacles!
- Replacing "bladder" in the head?
- Fuel guage fluctuation while engine running
- How to seal screws - deck hardware
- Winterizing 9.9 Mercury
- Remove the top batten
- fiberglass epoxy corners
- Rigging Tension
- Barient Winch Handle
- Removing a panel to make a sail smaller?
- Windicator
- Boomkicker Question
- Centerboard cable
- An alternator quickie...
- Save me before I wreck my spreader
- Building New Companionway Hatch - Columbia 29
- Ronstan Repair Shop for old gear?
- keel bolts project or not ?
- Best Autopilot for Offshore Work?
- Trailer Sailor - Mast Step
- Rule Mate 2000 Bilge Pump sticking on?
- Not just the fuel tank!
- Bird Poo on Sunbrella
- prop madness
- C30 prop advise needed
- bottom paint removal: sanding vs. stripping
- plugging holes in deck for winter storage
- need advice on modifying my storm jib..
- Force 5 Mast Needed any Ideas
- Changing fuel tank configuration...
- Tips on Kerosene tank location, pressurizing & fuel lines
- 316 verses 304 for strength?
- handheld chart ploter
- Shower Sump Pump
- another winch question
- refinish old winches
- Coaming boards revisited - apparently quartersawed wood makes a difference...
- Autohelm
- motor mounts replacement cost
- Yamaha outboard question
- Sail shape?
- Tinting windows to protect interior teak
- Soundproofing an Reverse Cycle AC Unit
- leaky hatch, project?
- MD2030 Which Volvo Filter? 3581621 or 3840525
- Replacing recess fixed ports w/stainless steel trim
- First Boat Qs - Beneteau FIRST35.7
- Rub rail repair
- AM FM Hidden In-Cabin Antenna
- Help-switch and warning light under companionway steps on Beneteau 390
- Keel bolts leak on '82 Hunter 30
- In mast roller furling gets stuck
- Motor for JabscoWater Pump Failure
- iPad Plan2Nav by Jeppesen
- Replacing Rudder
- Teak toe rail repair
- 1972 Pearson 390 Holding Tank
- Hatch lens replacement
- Autohelm ST4000+ rattle
- Kiwi Grip Pics
- How much zinc is enough?
- Bahamian Mooring
- Rudder Steering Failure
- Replacement glued teak deck
- Seasmoke's Last Stand....
- Damaged Furling Drum
- Mooring tackle
- Sail Track Tines Marine vs.MVBinfo/Dutchman
- Engine Pully's
- Keel Question
- Glassing over hull/deck joint
- I need a prop.
- Sail?
- Best finish for Ash
- thoughts on electronics
- Old coldplate
- Shore Power
- help with Merc 3.9 outboard...
- Radar and MFD, Broadband Vs Raymarine
- tillerlock vs tiller clutch
- Fiberglassing Over Plywood
- where to get a replacement whisker pole pin
- Repairing a Daggerboard
- navico tiller pilot problem
- Butyl Tape for Bolts, ???? for screws?
- Butyl Tape and leaking port-light
- water bladder cleaning and manual pump repair
- 3 inch flue through my 4 inch solar fan vent hole..
- Angle of Spreaders
- Removing old wax before buffing/rewaxing
- Outboard Prop
- Teak finish
- New Soft Shackle Design
- Storing mast on deck
- Leaking port lights
- Switching Batteries
- Scoring lines for the Boot stripe
- Too many holes in my boat how to close its?
- Seasmoke is coming available again...
- New Found Metals: TRI-Matrix Ports
- West Marine Binocular Recall?
- Genoa/Jib Tracks
- Has anyone painted their hull in the water?
- Differences between bottom paints
- Outboard Engine Repair
- Need Help Finding Instruments
- Seafarer 30
- Ablative bottom paint to VC-17
- Smoke in the cabin and my theory
- inflatable dinghy recommendations
- Sail re???
- Suzuki DT 2 points gap setting?
- Which Tiller Pilot
- 1991 Johnson 3 HP problem
- Water heater in 40ft Hunter
- wallas or wabasco?
- Standing Rigging replacement on Cape Cod
- Ancor LED bulb
- Coaming boards - Is epoxy flexible enough to conform to the bend?
- Don Casey: Paint Waterline Stripe with Bottom Paint
- Confused by Weems and Plath lantern
- Replacing Exhaust again...need to get it right this time
- Outboard Question
- Corrosion dye test
- Penofin Report
- Charging batterys from a 3500w generator
- Bedding one more time
- How to repair crack
- spreader replacement: bars or sleeves?
- Stainless or regular steel for exhaust nipple?
- Maintenance diffiulty/price for Oday 272?
- Headstay failure... Need Furlex parts!
- Backstay hardware, threaded or not?
- Main halyard tension, no winch
- Bringing another line back to cockpit
- jib thingamabob!
- Starwind 22 - Owners Manual ?
- Barnacles?
- Outboard, how long a shaft does it need to be?
- Looking for Deck Fill Plugs
- Rolling and tipping - the reality
- HRO 170 For Sale
- Help me ID mystery part?
- Integrating Raymarine X5 Smartpilot with Garmin 4208
- vented loop question
- U/V resistant/clear epoxy vs OR over top varnish - how to go?
- My mast is stuffed full of foam?
- Rigging a gennaker on a C&C 24
- Bungee cord please help me find
- Any 1977-82 Ensenada/Balboa 20 manuals available?
- Main and Jib Halyard, Online Stores?
- Sun cover for ST60 TriData Instrument
- Westerbeke 4-107
- Does size matter?? Wheel size, that is...
- Flare Up! Oct 15 New Rochelle NY
- Advice needed on non-mooring bottom paint
- OBM service "standards"?
- Bottom Paint Maintenance
- Catalina 25 split backstay tension
- best VHF ?
- Tartan 30 cradle measurements
- Corrosion on Blocks/how to remove?
- Well, *there's* your problem... (trashed my wheel pilot)
- Preventing sway when unstepping mast
- chainplate backing plates - G10, how thick?
- Australian Yacht Winch (Sales) PTY. LTD
- Used anchors..... ie Rocnas
- Advice on scuppers & drains
- SSB installion problem
- Tecsun PL-660 shortwave radio..
- Boom vang or mainsheet traveler?
- Rebuilding Yanmar 3GM30F; need advise $?
- T vent fitting in hot water line before mixing elbow.
- spreader repair/refurbishing
- Loads on my turning blocks?
- Mooring installation near Mystic CT
- Tabernacle Replacement
- LPG locker filling with seawater
- How to Modify Hours on a Tachometer
- rustoleum for keel bolts
- I hope this doesn't offend anyone...
- Profurl roller main halyard replacement
- prop shaft generators
- Pearson 32 Missing Rudder
- Help on cheap Fiberglass repair on boat
- Rocna Anhors
- Hull Deck joint caulking
- Replacing foam on couches and V berth
- coastal or off shore weather forecasts ?
- Self-Tailing Winch
- Where is Winch Access???? (Catalina 38)
- Bicycles...
- Draft vs water depth
- Harken Cam Cleat
- Batteries slow to charge from alternator
- Yanmar 2GM20F Tachometer troubleshooting
- Stainless steel anchors
- man overboard
- Another what is this?
- A re-do on a re-fit
- Prop very vulnerable to seaweed
- Scuba Compressor pricing
- Composite propane tanks
- Looking for portlights
- Electrophysics CT-33
- yanmar ysm8 must it have easystart?
- mast climbing a smaller keelboat
- Lubricating Roller Furling Foil
- Origo vs. Cookmate?
- Splice, replace or use as is
- Water heater popping GFCI
- Second shore power line
- Water heater options
- Re-Decking a Wooden Sailboat
- Keel Bolt Torque
- User Guide for Tanzer 7.5
- Jacklines
- Polish and Antifoul (lots of photos)
- Extra Oil OK?
- Faulty solenoid
- Port Light/Hole Gasket
- Dinghy Gas Tank Placement