- Outboard motor repair classes and SCUBA strategy
- Heat shrink tube for wire rope
- new to steel boats #2 neg ground
- Winch trouble
- Teak mast collar idea...
- Hull to deck joint question
- Honda 2hp smoking
- Lido 14 Cockpit Coating?
- adding cabinets in a v-berth
- diy safety harness
- Repairing a hole in deck - use core material of laminate
- new to steel boats
- glue for teak wood..
- any point in 120v lighting?
- Windlass Replacement: Tigres or H3?
- Speed Sensor Cleaning - While Afloat?
- PortVisors
- Chainplate Sealing
- Sloppy hatch install needs a fix
- Boat Stands
- we try a new to us technique for dealing with soft decks...
- Installing a 2nd mast Winch, Hunter 27.
- Blown sails?
- Sail lube / wax
- Airmar ST800/ST850 question - deadrise
- Excessive mast rake (with pic)?
- Proper installation of sea cocks
- What is a Tilley?
- Cleaning hull without removing wax
- New anchor comparison - results
- Smelly Fresh Water Tank
- Inverter/Charger questions
- Baggett and Sons on both coasts?
- thru hull and seacock size for 1973 irwin 28.5
- Mystery winch pawls
- How Crucial are Washers?
- Need advice on adding mizzen staysail
- Windlass Help
- Tip to get Hose on bronze elbow
- Painting a sail graphic?
- Air X wind generator
- Interchangability of thru-hull transducer makes
- Bimini for WD Schock Santana 30?
- black piano wood?
- docking line snubbers
- water in dinghy tubes
- are all grommets createed equal?
- Getting my 21' off the trailer for painting
- lining inside of cabin with wood
- Diesel Mechanic Dallas/FTW area
- sealing hatch glass with silaprene?
- Off Brand Norestar Anchor Quality
- Sea Gods drop Centerboard....
- 2 Part Main Halyard
- Source Starboard, Seattle/Tacoma area
- New traveller sizing for angled load?
- A very big jump forward! About the complete repair of my Swedish Koster
- In-water folding prop installation video
- Sea Dog Marine Products
- Teak Lumber Source on the West Coast?
- Cleaning the Deck...what to use?
- MaxProp Zinc replacement
- Ideas for cockpit shade
- Outboard lift davit for dinghy motor on 27' cal
- Pearson 35; moving wheel aft?
- What are these slots for?
- Stuffing box Nut
- Catalina 30 water in the bilge
- Need Help Rigging a Genoa
- Stuffing box: To drip or not to drip?
- Air Conditioning
- Managing / Supporting Hoses
- 12v Fan 4in Duct
- Repairing an Autohelm Drive Unit
- Making Lazy Jacks
- Lazy jacks
- Lady J post launch interior reveal
- Hunter 54 exterior reveal...
- To Dodger or not to dodger
- Want to Buy - Lofrans chain wheel (gypsy)
- Battery Charger - ProSport 12 - VGM vs. Gel settings - Problem
- Gravity holding tank does not drain
- More Spin questions;Crane, pole storage..
- HELP! Mystery leak is flooding my boat!
- Boom goosenecks! fixed or sliding?
- 1974 Columbia 23T mast
- What would you do with this thru hull?
- Water tank access cover leak
- Cabin Sole - Before & After
- Turn Buckle Pins
- New Leece-Neville alternator
- Removing glue/silicone from mahogany
- Spinlock deck vest?
- Newport 28 MK II 1985 leaky window
- Grounding strips
- Radar reflector
- Nordica/Danica 16 mast
- Mounting Whiskerpole track
- House battery question
- Bene 311 Traveller car
- Rigid Boom Vang?
- Interprotect 2000 Keel?
- voltage to radio
- storing reefing lines, not rigged
- Bow Eye problem/question...
- Catalina 30 Reefing
- After 19 years of feet dry, the Lady J launches...
- looking for 1970's triangular wind indicator
- Ball-squeezing can't be the only answer.
- Blower needed for inboard diesel?
- Warped dagger board
- California Copper Anti Fouling Paint Bill On Hold
- Cleaning the dirty bits....
- Pearson 30- stuffing box packing size?
- Kubota Diesel
- carry on a/c condensation problem
- Buying Solar Panel
- Buying Solar Panel
- Motor mount, Older Zodiac
- Autohelm ST3000-broken clutch
- Wheel with 1' square shaft; useless?
- Help convert from CNG to propane...
- Unknown sail control
- Old Yacht Specialty Pedastal guard
- Old Keel bolt repair
- Roller Furler Stupid Trick - Need Suggestions
- Water tank inspection cover
- bottom paint hard or ablative
- Whirlybird Windex
- When do you take down your canvas?
- Cockpit Cushions
- Bilge pump failure(s)
- A plea for helpand info
- How to seal around cable clam?
- Inflatable PFD's
- '82' C27 Electrical
- Internal boom bail
- Opinion on stakpack and dacron weight for racing use
- Engine Room Sound Insulation
- Forward Looking Sonar
- Sailing with rotten bulkhead?
- Interior Lighting Plan
- hot water issue
- Macerator Mystery
- Help with my Masthead Light
- Shaft removal on a Beneteau 461
- Volvo Penta MD11C engine (oil pressure)
- What speakers do you have in your sailboat saloon?
- what is this?
- proper knot to tie a flag to the back stay
- my compass doesn't spin..
- C33 Cable Lube
- Rusty propeller shaft bracket
- Lifeline upgrade
- Mr. Music Please!
- Non-skid; conflicting procedure?
- Reassembling Old Bronze Winch
- Need desesperatly a Paragon transmission P24L
- How BIG are your Digits?
- Blown Spreader on Cal 29
- A big thanks to Knothead
- Open CPN is cool. Why did no-one tell me before?
- Wilcox and Crittenden deck fill problem
- Whiz Bang Traveler
- But it's supposed to suck!
- Flickering Stove
- filling 4" deck hole - epoxy/fiberglass question
- 82 C27 Batteries
- Fishfinder not working
- Can you identify my roller furler?
- Shipmate Kerosene Stove/Oven not working
- Cabin Sole (Teak and Holly) refurbish
- Help point me in the right direction
- Rudder mould
- Store to buy a used or new spinnaker pole end
- Things that make your boat worth more?
- water heater stopped heating
- High and almost dry, looking for recommendations
- Environmentally friendly cleaning
- Gate for Slugs Thingy
- Stack pack cover vs traditional
- Bilge pump discharge setup
- asymmetric spinnaker design
- A thumping sound under foot
- 50 amp shore power cable
- Where to buy a rebuilt Yanmar 2YM15?
- Yikes! Shaft Broken
- Bilateral mooring cleats
- Zinc Collar on Pedestal Shaft, Okay?
- Outfitting a J24 - what is needed?
- Retrofit or Not?
- Wagner Autopilot Help!!!
- Two part Varnish or traditional?
- The right track for sail track
- Best hose for the head sea water intake?
- Calling all electic drive boats
- Holding Tank Paint
- Joker valve life
- Islander 28 electrical diagram
- Keel Repair
- Beneteau 473 Tank Level Sensor
- Battery Switch
- where to buy weather cloths?
- Sun Resistant Antenna Cables Attachments
- Trim teak caulk
- Loose Luff, How Come?
- Cam cleat for jib furler line?
- Teak & Holly Cabin Sole
- Galley cutting board
- Wire Lifelines vs Rigid Stainless steel??
- Deck Cleaning
- How heavy a solar panel can I mount on air x tower pole?
- Topside care
- Full a"head"
- Headboard Shackle
- Sailmaker recommendation Long Island
- Mooring pendant rubbing bow
- Fresh water tank vent 'dripping noise'
- New Sail from North?
- Setting up reefing lines
- Need help with ID on roller furling system
- Onan Genset on Amel Super Maramu
- DSC VHF Radio?
- How easily driven is a particular hull?
- Safely refueling an outboard motor
- prop question
- A prop-walk issue
- Attaching fairleads to mast boot
- weems plath mini lantern goes out..
- air conditioning
- Advice on Re-Gelcoating Topsides of a 30' hull
- running rigging replacement cost for a 30ft
- Another Outboard bracket question...
- Advice: Replacing Stuffing Box Hose
- Outboard Motor Mounting MADNESS!
- bilge detergant
- Datamarine S-200DL Deph Sounder replacement
- Used Sails
- Mooring loops too big for cleat
- Oil leak, need info about replacement parts, opinions
- Solvent for fender plastic / rubber?
- Deck fill plugs
- Best Waterproof Attire and Gear
- Yamaha 9.9 fuel issue
- Attaching velcro to canvas epoxy okay?
- SailNet Purchase Cudos
- Hull leaks
- Fiberglass deck cleaner
- patio deck stain???
- Barz Optics new Floater for Newport Show