Rob had asked about my
anchor roller he'd seen this summer when in Maine so here it is.
I first measured the inside width of the existing stem head and then went to Hamilton Marine and found a roller that was as close to that width as I could and one that would be long enough to keep my Rocna 33 from hitting my hull.
I wound up drilling two new holes in the stem head and through bolting with stainless bar stock. The new holes were very close to the aft existing stem head through bolt so my backing plate had to be notched slightly with my Dremel before it would fit flush.
The tang for the
furler was also in the way and I had to very carefully notch the
anchor roller, again with the Dremel, to make it fit. I was very careful not to have any sharp corners and made the notch with a nice smooth round bottom being careful to leave as much metal as possible so as not to weaken the roller more than totally necessary. It required much measuring and a cardboard mock up, of the roller, to make sure I had it right before cutting.
It should be noted that I NEVER use the roller to run my
anchor line through, when anchored, and always
cleat it off through the
chocks instead of the roller. Carrying the
anchor is fine when in transit, and in in calm seas, but I stow it in rough seas.
I also remove it and store it in my
anchor locker when on my mooring to prevent chafing of my mooring pendant! This is something any CS-36T owner should do if your leaving your boat unattended and on a mooring. The bow
chocks are in a poor location for
anchor chafe while moored...
Excuse the rust it was end of season! Note the machine screw going through the side of the roller and the stem head. This helps support that end of the roller after the notch I had to make.
This shows the two aft bolts. The front pre-drilled hole in the roller is too far forward to get a nut onto the under side of. Again if you use the
chocks, when anchoring, the roller is more than strong enough to hold a 35+ lb
anchor!
Why I don't keep an
anchor on the bow at the mooring! Picture three foot waves, yawing, and the sawing action of the
anchor on the pendants!
Linear Mode
