Yanmar 3gm30f - filter bleed screw
There must be a secret on how to tighten the bleed screw on the secondary fuel filter on this engine. Access is very difficult. How have you done it? On my Freedom 38 little room against the cabin bulkhead on the starboard side of the engine. There is a screw directly next to it.
Can't get a screw driver in there, very hard to get a 10mm closed end wrench on it.
Also, how much do you tighten it against the new brass washer? I'm figuring until it doesn't leak when I pump the primer pump.
Any advice would be appreciated.
|All times are GMT -4. The time now is 08:46 AM.|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.
User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.
(c) Marine.com LLC 2000-2012