General discussion - Page 3 - SailNet Community
 1Likes
Reply
 
LinkBack Thread Tools
post #21 of 56 Old 02-27-2012 Thread Starter
Senior Member
 
MarioG's Avatar
 
Join Date: Sep 2009
Posts: 405
Thanks: 0
Thanked 7 Times in 7 Posts
Rep Power: 6
 
heres my replacment ports
MarioG is offline  
Quote Quick Reply Share with Facebook
Sponsored Links
Advertisement
 
post #22 of 56 Old 03-18-2012
Junior Member
 
Join Date: Jan 2012
Location: Philadelphia
Posts: 22
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
 
Re: General discussion

Very nice!!!



Amy
Utopia
37' Endeavour Owner




Twenty years from now you will be more disappointed by the things that you didn't do than by the ones you did do. So throw off the bowlines. Sail away from the safe harbor. Catch the trade winds in your sails. Explore. Dream. Discover. -Mark Twain
S/V Utopia is offline  
Quote Quick Reply Share with Facebook
post #23 of 56 Old 03-22-2012
No more curry buffets
 
Ritchard's Avatar
 
Join Date: Aug 2011
Location: Toronto
Posts: 406
Thanks: 3
Thanked 6 Times in 6 Posts
Rep Power: 4
 
Re: General discussion

Oh my my. Yesterday I polished the topsides of the old girl with 3M imperial Compound and a wool pad on a 7 inch polisher. It came out amazing! Despite a pretty dull appearance beforehand, it came out glossy and gorgeous. I also tested a couple of spots on the decks with the same compound, where the sun had really beat the boat for years and it is REALLY chalky. I am not sure that this material has enough cutting capability for that much oxidation. I am going to try once more.

A question for E32 owners - do you have genoa tracks? If so, where/how?

Bashing about on Lake Ontario and Beyond
"Ariel" '79 Endeavour 32
Ritchard is offline  
Quote Quick Reply Share with Facebook
post #24 of 56 Old 03-25-2012
Senior Member
 
bigdogandy's Avatar
 
Join Date: Jun 2008
Location: Fort Lauderdale, Florida
Posts: 464
Thanks: 8
Thanked 16 Times in 16 Posts
Rep Power: 8
 
Re: Endeavour 32 cockpit cushions

This post may belong in the classifieds section, but since it's Endeavor 32 specific I hope it's OK to post it here: I have a set of cockpit cusions for sale. They are foam with sunbrella covers, are in good shape, and make the cockpit tremendously more comfortable. In the spirit of full disclosure, they work best when they are kept dry because they will absorb moisture. ....I typically store them in the quarter berth. Asking $100 plus shipping costs. Respond to this post or PM me if you're interested. Thanks.


Attached Thumbnails
_DSC1527small.jpg  

Andy
Key Largo
S/V Everlasting Moon
1981 Endeavour 32

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.


Be joyful though you have considered all the facts.
- Wendell Berry
bigdogandy is online now  
Quote Quick Reply Share with Facebook
post #25 of 56 Old 03-25-2012
No more curry buffets
 
Ritchard's Avatar
 
Join Date: Aug 2011
Location: Toronto
Posts: 406
Thanks: 3
Thanked 6 Times in 6 Posts
Rep Power: 4
 
Re: General discussion

I might be interested, if you could make the pics work.

I clicked the links and saw them. Any chance you could figure out shipping to toronto M1N2V4 Canada?

Bashing about on Lake Ontario and Beyond
"Ariel" '79 Endeavour 32

Last edited by Ritchard; 03-25-2012 at 09:37 PM.
Ritchard is offline  
Quote Quick Reply Share with Facebook
post #26 of 56 Old 03-26-2012 Thread Starter
Senior Member
 
MarioG's Avatar
 
Join Date: Sep 2009
Posts: 405
Thanks: 0
Thanked 7 Times in 7 Posts
Rep Power: 6
 
Re: General discussion


The 1st mate just recovered our cockpit cushions, and I'm sure it cost alittle more then $100 just in materials but we wouldn't do with out them , makes hangout in the cockpit very comfortable.
MarioG is offline  
Quote Quick Reply Share with Facebook
post #27 of 56 Old 04-16-2012
Junior Member
 
Join Date: Jan 2012
Location: Philadelphia
Posts: 22
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
 
Re: General discussion

Ok guys...so I think I may have added another project to the Captain's list...I ripped all the overhead vinyl and foam down last weekend and now we have this....Any and all suggestions are welcomed!!!
Attached Thumbnails
overhead.jpg  



Amy
Utopia
37' Endeavour Owner




Twenty years from now you will be more disappointed by the things that you didn't do than by the ones you did do. So throw off the bowlines. Sail away from the safe harbor. Catch the trade winds in your sails. Explore. Dream. Discover. -Mark Twain
S/V Utopia is offline  
Quote Quick Reply Share with Facebook
post #28 of 56 Old 04-16-2012
No more curry buffets
 
Ritchard's Avatar
 
Join Date: Aug 2011
Location: Toronto
Posts: 406
Thanks: 3
Thanked 6 Times in 6 Posts
Rep Power: 4
 
Re: General discussion

The previous owner of my E32 redid the ceiling with a lovely off-white vinyl, and it came out beautiful. Apparently it was tricky, but I'd say worth it.

Bashing about on Lake Ontario and Beyond
"Ariel" '79 Endeavour 32
Ritchard is offline  
Quote Quick Reply Share with Facebook
post #29 of 56 Old 04-16-2012
Junior Member
 
magicmoments's Avatar
 
Join Date: Jan 2009
Location: Chatham Ontario
Posts: 18
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
 
Re: General discussion

On my E37 it seemed the factory applied the vinyl head liner in one piece when the deck was upside down.
How I did it was use inch plywood and cut it into pieces to fit the origional sections between the battens, and placed the joints under the battens that run across the ceiling. I split it down the middle as well to keep the pieces small and managable. I sprayed contact cement on the plywood, and glued inch foam to it and then glued new vinyl on top, wrapped it around the edges and used SS staples to hold it. By keeping the sections small it was not a bad job. The only tough spot was the support post near the nav station, I ended up splitting a section at the post, half in front and half aft. There is lots of deck to hold screws so I used wood screws with fender washers in the joints between the sections, the battens cover the washers and also screws are between the sections.
I was able to do a so so match on the batten material by buying oak moulding the same size and staining it to match.
Now if I have a leak I can just remove one piece of batten and drop the section of ceiling.
This is a link to my site of the headliner job.
Endeavour 37 headliner

" I get by with a little help from my friends "

Last edited by magicmoments; 04-16-2012 at 09:22 PM.
magicmoments is offline  
Quote Quick Reply Share with Facebook
post #30 of 56 Old 04-19-2012
Junior Member
 
Join Date: Jan 2012
Location: Philadelphia
Posts: 22
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
 
Re: General discussion

WOW, that came out really nice! For whatever reason we have a bunch of choppy plywood pieces on the overhead...we were thinking of filling them in then painting it but it doesn't provide much insulation...I like what you did!!!



Amy
Utopia
37' Endeavour Owner




Twenty years from now you will be more disappointed by the things that you didn't do than by the ones you did do. So throw off the bowlines. Sail away from the safe harbor. Catch the trade winds in your sails. Explore. Dream. Discover. -Mark Twain
S/V Utopia is offline  
Quote Quick Reply Share with Facebook
Reply

Quick Reply
Message:
Options

By choosing to post the reply above you agree to the rules you agreed to when joining Sailnet.
Click Here to view those rules.

Register Now



In order to be able to post messages on the SailNet Community forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
Please note: After entering 3 characters a list of Usernames already in use will appear and the list will disappear once a valid Username is entered.


User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in









Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.




Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page



Similar Threads
Thread Thread Starter Forum Replies Last Post
Boatyard Discussion Cheetie Gear & Maintenance 59 03-19-2009 09:31 AM
general question for a general discussion hillbillybear General Discussion (sailing related) 4 09-03-2008 05:02 AM
Welcome to General Discussion messageboard General Discussion (sailing related) 6 06-27-2007 10:06 PM
Is cruising only for my parents? sorry, posted this one is general discussion too Newport41 Cruising & Liveaboard Forum 68 01-24-2007 12:25 AM

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome