SailNet Community

SailNet Community (
-   Gear & Maintenance (
-   -   prop shaft assy (

pmcandrew 01-23-2005 04:12 PM

prop shaft assy
I removed the coupling flange from the prop shaft on my boat using a three jaw puller. It is a keyed shaft with set screws, but was a press fit onto the shaft. Does anyone have a good method for re-installing the flange onto the shaft? I removed it to install a dripless packing.

Denr 01-23-2005 04:41 PM

prop shaft assy
It was most likely not a press fit, rather than a bit of corrosion between the steel/iron flange and the bronze shaft. Suggest that you clean up the shaft with some emery cloth and use a little lubricant to reinstall the shaft into the coupling. A light tape is all that will be required as this is, and should be a close fit. Check the key for any steps that might be in it and replace it if any are found. You''ll like the dripless packing, I did this several years ago as one of the first upgrades to the boat I currently own, Packing flax, bronze nuts and drip-drip-drip are nonsense!

All times are GMT -4. The time now is 06:19 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2016, vBulletin Solutions, Inc.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.
User Alert System provided by Advanced User Tagging v3.1.0 (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.
(c) LLC 2000-2012

For the best viewing experience please update your browser to Google Chrome