SailNet Community

SailNet Community (http://www.sailnet.com/forums/)
-   Gear & Maintenance (http://www.sailnet.com/forums/gear-maintenance/)
-   -   Chain Plate Replacement (http://www.sailnet.com/forums/gear-maintenance/11602-chain-plate-replacement.html)

jsutor 04-30-2005 03:29 PM

Chain Plate Replacement
 
Upon inspection of the rig on my Morgan OI33 4 of the 7 chain plates are cracked, my initial response is to replace all (I have just about recovered from a quote received) and not weld the cracks. They are constructed of 1 X SS flat bar and I am considering making them from heavier material. Any comments on materials and the sizing?

RichH 04-30-2005 03:40 PM

Chain Plate Replacement
 
By all means make them thicker and wider if possible. Normal 316 or 316L is fine. To help mitigate fatigue in the future put a highly polished finish on all the surfaces: sand (180 then 320 then 400 grit) then polish (Tripoli, etc.) to a mirror surface. No welds, no surface irregularities - no notches, bends, etc.

Larger cross section will give you more *load cycles" and the mirror polish will help prevent the micro crack formation. Fatigue cracks are additive and the more ''meat'' you use will provide longer service.

Dont wait as the price of stainless steel is rapidly escalating at this time. The longer you wait the more you are going to pay.



All times are GMT -4. The time now is 11:01 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012