Using the outboard to charge battery - SailNet Community

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > On Board > Gear & Maintenance
 Not a Member? 
  #1  
Old 03-03-2006
Junior Member
 
Join Date: Feb 2006
Location: Hampton Roads, Virginia
Posts: 16
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
lightyear22 is on a distinguished road
Using the outboard to charge battery

On my SailMaster outboard it has a charger in it for charging the 12v battery. I took a reading with the voltometer anf it is putting out alot more than 12v. I am thinking that when it is hooked up to the battery it will put a load on the charger and do what it is supposed to. Is this correct. I have read that people use the 12v outlet in the cabin to connect to the electical and charge the battery from there. Will this effect my other wiring in the boat? Will it cause any damage to my wired in xantrex shore power charger? I do alot of night sails and would like to keep the battery up and the lights on.

Thanks
Andrew
Reply With Quote Share with Facebook
  #2  
Old 03-04-2006
Senior Member
 
Join Date: Dec 2002
Posts: 552
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 12
GordMay is on a distinguished road
Charging Voltage over 13.8VDC

Depending upon your battery type (and ambient temperatures), typical Charging Voltages are always considerably higher than 12Volts.

Bulk (Absorption) Rate:
Flooded Lead Acid: 14.4VDC (@ normal temp. 77 deg. F - Lower V for Hot temperatures, and Higher V for Cold temps.)
AGM: 14.3VDC
Gel: 14.2VDC

Float Rate:
Flooded: 13.5VDC
AGM: 13.4VDC
Gel: 13.8VDC

Be aware that your small outboard may not have a “Regulated Output” alternator, suitable for Battery Charging. Many small O/Boards only have an “Unregulated” power supply, suitable for operating lights.

HTH,
Gord May
Reply With Quote Share with Facebook
  #3  
Old 03-04-2006
Junior Member
 
Join Date: Feb 2006
Location: Hampton Roads, Virginia
Posts: 16
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
lightyear22 is on a distinguished road
I think it is unregulated. Does this mean I need to install a switch so I may switch just the lights over to the O/B? When I took the O/B in for service last year. The service man said that the charger was working correctly and that it was unregulated.

Andy
Reply With Quote Share with Facebook
  #4  
Old 03-04-2006
Senior Member
 
Join Date: Dec 2002
Posts: 552
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 12
GordMay is on a distinguished road
SPDT Switch

Yes, a Single Pole Double Throw Switch (Centre Off), applied as a DC Source Selector to the Navigation Lights.
The "Common" (Centre) pole goes to the Lights.
One Switched Terminal comes from the Outboard Alternator Output, & the Other Switched Terminal from the Batrery.

Alt ----------0
Centre 'Off' > 0---- Lights
Batt --------0

Last edited by GordMay; 03-04-2006 at 03:12 PM.
Reply With Quote Share with Facebook
  #5  
Old 03-04-2006
Member
 
Join Date: Nov 2002
Posts: 54
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 12
BeneteauMark is on a distinguished road
Charge/run lights with outboard -- check amps, too

It wouldn't hurt to check the amp output from your outboard's alternator before proceeding. My 5hp OB's alternator only put out 2 amps at crusing rpm, which wasn't enough to do anything with.

Before rearranging wiring to run your nav lights from the outboard, if you're doing a lot of night sailing, what is the total amp draw from your nav lights? (The aggregate draw from my bow light and stern light is only 2-3 amps. You can get a lot lower than that with LED nav lights.) Realistically, a decent group 24 deep cycle battery should power the lights overnight, and you could recharge once returning to the dock. Seems simpler to me than splicing in a switch to chose between battery and alternator power.


Mark
One Step Closer
Lake St. Clair, MI
Reply With Quote Share with Facebook
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools

 
Posting Rules
You may post new threads
You may post replies
You may post attachments
You may edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Solar Power for Battery Charge KnotaClew23 Gear & Maintenance 1 09-23-2005 03:40 PM
Battery loses charge svzephyr44 Gear & Maintenance 1 09-28-2004 02:20 PM
house batteries seac Gear & Maintenance 9 08-23-2004 04:28 AM
Adding 2nd Battery...help redbeard58 Gear & Maintenance 2 03-03-2003 06:13 PM
Dual Battery Installation Urband Gear & Maintenance 1 03-25-2002 08:57 PM


All times are GMT -4. The time now is 05:06 PM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012