SailNet Community

SailNet Community (http://www.sailnet.com/forums/)
-   Gear & Maintenance (http://www.sailnet.com/forums/gear-maintenance/)
-   -   converting wheel-->tiller (http://www.sailnet.com/forums/gear-maintenance/3155-converting-wheel-%3Etiller.html)

abeetung 01-27-2002 12:57 PM

converting wheel-->tiller
 
My husband and I are looking for a bigger boat (30-35 ft) and we definitely want tiller steering. Some of the boats we are interested in have wheels. How difficult would it be to convert to tiller? What things need to be considered? Thanks!

Catherine

RichH 01-27-2002 06:54 PM

converting wheel-->tiller
 
Depends on the shape of the rudder: whether it is a barn door hinged type that requires lots of tiller pressure or if its a balanced spade rudder which is naturally balanced. Sometimes a skeg hung barn door type can be modified to become a balanced rudder. I agree with you on wanting a tiller.... but the rudder shape will be the determining factor.

Jeff_H 01-27-2002 07:31 PM

converting wheel-->tiller
 
I very much agree with you that a tiller is the only way to go on a well designed boat between 30 and 35 feet. The difficulty converting from tiller to wheel very much depends on the particular boat. In most cases with wheel steering, there is a set up that allows for a temporary tiller. This setup varies quite widely in terms of layout and effectiveness. In most cases, on a 30 to 35 footer there is an access plate that allows access to the top of the rudder post and the rudder post terminates in a fitting intended to recieve a fitting on the bottom of the emergency tiller.

In the best case, you will need to constuct a simple bushing or bearing at the deck to support a short rudder post extension. At the bottom of this extension post you will need a fitting that will solidly engage the top of the rudder post. At the top of this post you will need a tiller fitting and tiller. In the best case you could probably make the whole thing for a few hundred dollars. In the worst case it could cost thousands. Your best hope is to look for models that offered both tiller and wheel versions because generally these are most easily adapted.

Good luck,

Jeff


All times are GMT -4. The time now is 05:55 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012