Mainsail questions on 1978 Seafarer 30 - SailNet Community

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > On Board > Gear & Maintenance
 Not a Member? 
  #1  
Old 10-24-2007
Senior Member
 
Join Date: Jan 2007
Posts: 387
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 8
Northeaster is on a distinguished road
Mainsail questions on 1978 Seafarer 30

Although my mainsail is original, it really doesn't seem too "bellied out", I assume because it is not large, to start with, and therefore may not stretch as much as larger ones?
If I decide to replace it in the next couple of years, I have a couple of questions on getting a new one made:

1. The original mainsail has a boltrope, that attaches the bottom 5 or 6 slugs to the sail's luff. All higher slugs are sewn onto the luff. I can put a single reef in, without undtying the boltrope, or taking any slugs out of the mast. I may be doing something wrong, but when I need to put a 2nd reef in, I untie the boltrope, to allow some slack to through the bottom slugs, as otherwise, I the tack would not be able to come low enough - ie. close to the boom. I could take out the mast bolt, which prevents the slugs from falling out, and allow the bottom ones to come out, so the tack can fall low enough.
If I had a new mainsail made, would they use this same arrangement, or can they use shorter slugs, or something, so that they will all fit into the mast track, and therefore don't require the boltrope. My 1982 Seafarer 23 did NOT have a boltrope - all slugs were attached directly to the luff.
Is there a benefit, or other purpose for the boltrope, like for sail-trim, that I don't know about. I have only been sailing for 2 seasons, mostly self-taught, so it's highly possible that I have missed something!!

2. My mainsail has an outhaul block and track, that i used to keep the clew back, when reefed. However, the real clew is permanently attached to the end of the boom via a clevis pin attached to a connector lashed to the clew.
Is this normal? My Seafarer 23's mainsail was a little shorter than the boom, so there was room at the end to connect a line, through a block, for a change of direction, and then to the outhaul track. As the real mainsail clew is only a couple of inches from the end of the boom, and is farther aft than the outhaul block and track, I don't see how it could be hooked up / adjusted otherwise.

3. If I did splurge for a new main, any suggestions on brands and types (ie loose footed). Would I see much of a performance gain, given that most of the power comes from the headsail, with this type of smaller mainsail? Boom is only 9.8ft (I=37.3, J=12.6, P=31.8, E=9.8)

Any input or other considerations would be appreciated!
Reply With Quote Quick reply to this message Share with Facebook
Reply

Quick Reply
Message:
Options

By choosing to post the reply above you agree to the rules you agreed to when joining Sailnet.
Click Here to view those rules.

Register Now

In order to be able to post messages on the SailNet Community forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
Please note: After entering 3 characters a list of Usernames already in use will appear and the list will disappear once a valid Username is entered.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.




Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools

 
Posting Rules
You may post new threads
You may post replies
You may post attachments
You may edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Looking for an used mainsail for Seafarer 24 HenryNguyen Gear & Maintenance 8 08-11-2012 06:02 PM
Upgrading Your Mainsail System Sue & Larry Her Sailnet Articles 0 11-17-2002 08:00 PM
Basic Mainsail Trim for Racers, Part Two Pete Colby Racing Articles 0 12-02-2001 08:00 PM
Mainsail Controls for Performance Dan Dickison Gear and Maintenance Articles 0 07-04-2001 09:00 PM
Mainsail Controls for Performance Dan Dickison Racing Articles 0 07-04-2001 09:00 PM


All times are GMT -4. The time now is 04:46 AM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.