Dutchman Flaking System - SailNet Community

   Search Sailnet:

 forums  store  


Quick Menu
Forums           
Articles          
Galleries        
Chat  
Boat Reviews  
Classifieds     
Search SailNet 
Boat Search (new)

Shop the
SailNet Store
Anchor Locker
Boatbuilding & Repair
Charts
Clothing
Electrical
Electronics
Engine
Hatches and Portlights
Interior And Galley
Maintenance
Marine Electronics
Navigation
Other Items
Plumbing and Pumps
Rigging
Safety
Sailing Hardware
Trailer & Watersports
Clearance Items

Advertise Here






Go Back   SailNet Community > On Board > Gear & Maintenance
 Not a Member? 
  #1  
Old 06-10-2008
artbyjody's Avatar
Senior Member
 
Join Date: Jan 2008
Location: Bellingham, PNW
Posts: 3,146
Thanks: 0
Thanked 1 Time in 1 Post
Rep Power: 11
artbyjody is just really nice artbyjody is just really nice artbyjody is just really nice artbyjody is just really nice
Dutchman Flaking System

[couldn't delete - found answer on the manufacturers website, disregard below]

We have had a pretty nasty storm come through this afternoon. When I got to the boat after the marina call to double check the fender status as one had popped out and hull went a little bouncy bouncy - I discovered that the topping lift didn't seem right as the boom was on the bimini.

Closer inspection revealed that both sides of the most forward Dutchman guide lines had popped off. I imagine it would of happened sooner or later as there was evidence of chaffing pretty much all along the top most parts of the plastic filament.

So question I ponder the experts ...Could I use that lite weight thin spectra line instead as a replacement? Any one have any experience with it and things I should be wary of?
__________________
-- Jody

S/V "
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
" -
1983, Barberis Show 38! or
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.



To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.








Last edited by artbyjody; 06-10-2008 at 12:45 AM.
Reply With Quote Quick reply to this message Share with Facebook
  #2  
Old 06-10-2008
sailingdog's Avatar
Telstar 28
 
Join Date: Mar 2006
Location: New England
Posts: 43,290
Thanks: 0
Thanked 14 Times in 12 Posts
Rep Power: 14
sailingdog is just really nice sailingdog is just really nice sailingdog is just really nice sailingdog is just really nice sailingdog is just really nice
JOdy-

If you found the answer on the manufacturer's website, you could post what you found here...in case anyone else needs that info.
__________________
Sailingdog

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.

Telstar 28
New England

You know what the first rule of sailing is? ...Love. You can learn all the math in the 'verse, but you take
a boat to the sea you don't love, she'll shake you off just as sure as the turning of the worlds. Love keeps
her going when she oughta fall down, tells you she's hurting 'fore she keens. Makes her a home.

—Cpt. Mal Reynolds, Serenity (edited)

If you're new to the Sailnet Forums... please read this
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
.

Still—DON'T READ THAT POST AGAIN.
Reply With Quote Quick reply to this message Share with Facebook
  #3  
Old 06-10-2008
JohnRPollard's Avatar
Moderator
 
Join Date: Mar 2007
Location: Chesapeake
Posts: 5,680
Thanks: 0
Thanked 3 Times in 3 Posts
Rep Power: 10
JohnRPollard is a jewel in the rough JohnRPollard is a jewel in the rough JohnRPollard is a jewel in the rough
Yes, please post the answer. Enquiring minds (with similar chafe on their monofilament ) would like to know. Thanks.
__________________

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.

Pacific Seacraft Crealock 31 #62

NEVER CALLS CRUISINGDAD BACK....CAN"T TAKE THE ACCENT
Reply With Quote Quick reply to this message Share with Facebook
  #4  
Old 06-10-2008
artbyjody's Avatar
Senior Member
 
Join Date: Jan 2008
Location: Bellingham, PNW
Posts: 3,146
Thanks: 0
Thanked 1 Time in 1 Post
Rep Power: 11
artbyjody is just really nice artbyjody is just really nice artbyjody is just really nice artbyjody is just really nice
I did - I provided the documentation link But yes, one may use Spectra - or if they read the manual, you can get instructions on how to get a free replacement of those particular lines. The lines themselves can be purchased at any hardware / fishing store just do not use the weed waker variety. I am going to use the spectra myself for longevity reasons.
__________________
-- Jody

S/V "
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
" -
1983, Barberis Show 38! or
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.



To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.







Reply With Quote Quick reply to this message Share with Facebook
  #5  
Old 06-11-2008
artbyjody's Avatar
Senior Member
 
Join Date: Jan 2008
Location: Bellingham, PNW
Posts: 3,146
Thanks: 0
Thanked 1 Time in 1 Post
Rep Power: 11
artbyjody is just really nice artbyjody is just really nice artbyjody is just really nice artbyjody is just really nice
I ended up replacing the line with Marlow VC type. Its the same width, its higher breakage, and if it shreds its 12 bucks for 50 feet of it. And its colored..

The drawbacks to it is that it as not as knot resistant as the filament used stock with it. But, for the cost - I am willing to see how it works out...
__________________
-- Jody

S/V "
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
" -
1983, Barberis Show 38! or
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.



To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.







Reply With Quote Quick reply to this message Share with Facebook
  #6  
Old 06-11-2008
Junior Member
 
Join Date: Oct 2005
Posts: 1
Thanks: 0
Thanked 0 Times in 0 Posts
Rep Power: 0
andermark is on a distinguished road
Hi Jodi,
You posts on the dutchman were very helpful.

By the way, I noticed you have a Barberis Show 38. I am considering buying a 1983 Barberis Show 34. Do you have any suggestions, information, cautions, links? I am having a difficult time getting much information about these boats.
Thanks, Mark
Reply With Quote Quick reply to this message Share with Facebook
  #7  
Old 06-11-2008
artbyjody's Avatar
Senior Member
 
Join Date: Jan 2008
Location: Bellingham, PNW
Posts: 3,146
Thanks: 0
Thanked 1 Time in 1 Post
Rep Power: 11
artbyjody is just really nice artbyjody is just really nice artbyjody is just really nice artbyjody is just really nice
Quote:
Originally Posted by andermark View Post
Hi Jodi,
You posts on the dutchman were very helpful.

By the way, I noticed you have a Barberis Show 38. I am considering buying a 1983 Barberis Show 34. Do you have any suggestions, information, cautions, links? I am having a difficult time getting much information about these boats.
Thanks, Mark
Thanks

here is a link to my post-purchase review on the Baberis: http://www.sailnet.com/forums/buying...tml#post327670
__________________
-- Jody

S/V "
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
" -
1983, Barberis Show 38! or
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.



To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.








Last edited by artbyjody; 06-11-2008 at 12:01 PM.
Reply With Quote Quick reply to this message Share with Facebook
Reply

Quick Reply
Message:
Options

By choosing to post the reply above you agree to the rules you agreed to when joining Sailnet.
Click Here to view those rules.

Register Now

In order to be able to post messages on the SailNet Community forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
Please note: After entering 3 characters a list of Usernames already in use will appear and the list will disappear once a valid Username is entered.
User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.
Password:
Confirm Password:
Email Address
Please enter a valid email address for yourself.
Email Address:

Log-in

Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.




Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools

 
Posting Rules
You may post new threads
You may post replies
You may post attachments
You may edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Dutchman Sail Flaking System Problem Trescool Gear & Maintenance 4 07-29-2007 01:41 AM
Refrigeration—Part II Selecting a System Tom Wood Gear and Maintenance Articles 0 05-19-2003 08:00 PM
Upgrading Your Mainsail System Sue & Larry Her Sailnet Articles 0 11-17-2002 07:00 PM
Dutchman vs. Lazy Jacks Pros and Cons SailNet Gear and Maintenance Articles 0 04-05-2001 08:00 PM
Lazy-Jack or Dutchman System Dan Dickison Gear and Maintenance Articles 0 01-17-2001 07:00 PM


All times are GMT -4. The time now is 06:29 PM.

Add to My Yahoo!         
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012

The SailNet.com store is owned and operated by a company independent of the SailNet.com forum. You are now leaving the SailNet forum. Click OK to continue or Cancel to return to the SailNet forum.