Thru Hull Hole Sizing
I'm installing a new 3/4" ID thru hull (forespar marelon). The actual hole sizing required is at least 1 1/16". Should I oversize the hole (i.e. 1 1/8 or 1 1/4) so that there's plenty of room for sealant or size it as accurately as possible. Any Thoughts?
Drill the hole as close to the correct size as possible to give the fitting the greatest mechanical strength.
|All times are GMT -4. The time now is 10:21 PM.|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012