Flying Scot Rudder Fitting
I have been sailing a Flying Scot for the past couple of months.
Today I went to sail and the upper transom rudder fitting was separated from the hull.
1) What are the appropriate bolt sizes?
2) What, exactly, are the bolts screwing in to? In other words - I see from the outside - the four holes for the fitting - but I'm concerned that the 'female' part - where the bolt goes in - might be stripped out. This is why I'm wondering what the bolts might be screwing in to.
Any further detail on this topic would be greatly appreciated.
|All times are GMT -4. The time now is 05:13 AM.|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2015, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012