Tacktick Mounting Opinions/Questions
Replacing the 2 old Datamarine Speed and Depth w/ T108 Wind and Dual Display Speed/Depth. I like what Sailingdog did by mounting his in a single opening port, but I'd like to consider using the existing cutouts for the new instruments w/o cutting or drilling any new holes.
The 2 TT displays are removable from their mounts so I was considering mounting a deck plate into each of the 2 existing 4" holes and simply securing the TT mounts to those plates. What I'd rather not do, is drill additional wholes around the circumference of the trim ring on the deck plate.
I found these compression deckplates, although they're of the wrong diameter, it's the general idea:
Water tight Deckplates by Armstrong Nautical Products
Here's what I'm imagining:
I too replaced my old datamarine stuff with Tack Tick. As a temporary solution (someday I will glass it over properly) I covered the old holes with Starboard then attached the Tack Tick mounts to that, plus I made up some mounts for the helm, so I can move them to the helm or bulkhead in the cockpit depending on the need. Both areas get enough light to keep them charged. I thought about using team but the thought of more brightwork changed my mind :) LOL
|All times are GMT -4. The time now is 10:49 AM.|
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012