SailNet Community

SailNet Community (http://www.sailnet.com/forums/)
-   Introduce Yourself (http://www.sailnet.com/forums/introduce-yourself/)
-   -   Ahoy from the SF Bay (http://www.sailnet.com/forums/introduce-yourself/50893-ahoy-sf-bay.html)

jgsteven 01-27-2009 02:01 PM

Ahoy from the SF Bay
 
1 Attachment(s)
Hello!

I recently moved to the SF Bay area, and bought a 1969 Discovery 32, an older and very simply appointed 'plastic classic'. The hull was in great shape and the boat had been re-powered with a Yanmar diesel about 10 years ago, but had almost nothing in the way of interior furnishings or electronics. Over the winter months of 2008 and 2009 I have been working on updating it a bit (GPS, automatic bilge pump) and getting it ready for an active summer on the bay and the pacific coast.

camaraderie 01-27-2009 02:36 PM

Nice looking boat! Welcome aboard.

sailortjk1 01-27-2009 03:43 PM

Welcome, can't wait to hear more about your refit/projects.

jgsteven 01-27-2009 07:19 PM

Upgrade project: electrical system
 
1 Attachment(s)
Well, my most recent refit was adding AC shore power (Jan 09). I installed a very simple system, only to power an onboard battery charger and one electrical outlet (GFCI equipped, of course).

It was pretty straightforward, although there are a couple of things I learned that might be useful to others:

1. Blue Sea systems makes a really great set of pre-fab panels that have all the breakers installed. I got one with a 30A double pole and 3 15A single pole breakers as well as a voltmeter and reverse polarity warning light for less than $200.

2. Marinco GFCI's wire sockets aren't large enough for real wire (who wires their boat with 16 gauge wire?!?!). I got a tip from another owner with the same problem who told me you could force the holding screws out of the outlet, and use ring terminals (which worked) but I was pretty disappointed in the quality of the Marinco GFCI. I suspect I could have gotten an identical quality one from Home Depot for cheaper (that didn't say 'Marine' on it).

Finally, I also had to make a little wood panel to mount it on and I used 'West Marine Semi Gloss Wood Finish' instead of varnish for the first time. It offers the benefit of no thinning or sanding between coats, and you can overcoat it with varnish. The panel turned out well (picture below) so I think I am going to try this on my brightwork once the weather gets a little warmer.

Regards,

--
Joe


All times are GMT -4. The time now is 04:17 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO 3.6.1
(c) Marine.com LLC 2000-2012