Spreader for Islander 30 Bahama

OopsIslander · #1 (**permalink**) 05-17-2006

Looking for a replacement for a lower spreader for an Islander 30 bahama. Tried dwyer mast with no luck, wrong sizes. Anyone know where to find a spreader? or the extrusion? or if another boat uses the same spreader?

Dimensions are 38 inches from mast to wire, 3.25 wide by five sixtenth inch (5/16) thick.
There are two bolt holes 2.375 inches (2 and 3/8) apart.

jheldatksuedu · #2 (**permalink**) 07-04-2006

I have a couple sets of spreaders, a pair 60 inches long and another pair 47 inches, airfoil shape tapered the last 8 inches or so. jheld@ksu.edu
I'm in Labelle, Fl. The spreaders are here, but will probably travel to Manhattan, Ks sometime. I also have a mast for a Cal25 in Mobile,Al. These spreaders came from about a 50 foot boat, there was nothing wrong with them, they ordered new mast stays and new spreaders came with them, these are the old ones.

tikibum2 · #3 (**permalink**) 09-10-2008

there are a pair of teak spreaders on ebay for sale that are a bit larger then yours but could easily be cut to fit,bidding is at .99 cents
teak is just as strong as aluminum and will last as long with little maintenance...

hope this helps