SailNet Community - Reply to Topic
Thread: Grounded!!!??? Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the SailNet Community forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.
Please note: After entering 3 characters a list of Usernames already in use will appear and the list will disappear once a valid Username is entered.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

  Additional Options
Miscellaneous Options

Click here to view the posting rules you are bound to when clicking the
'Submit Reply' button below

  Topic Review (Newest First)
03-27-2002 03:22 PM

You can install a grounding plate near your centerboard well and run the engine ground to that. Now it doesn''t matter if the engine is up or down
2. Install another ground plate straight below the mast(electricity doesn''t like to turn corners). Now run your no. 4(at LEAST no. 4) to that. I think the best way to avoid a lighting strike is to avoid a lighting strike. This can be done by not allowing the static electricity to build up. Lightning just doesn''t strike, it is "provoked" by static electricity building up in your rigging and then jets skyword in the form of a streemer luring the strike. A electrical engineer told me the best thing to do to avoid this is to cable clamp a no. 6 tinned wire to the upper shroud base on each side of the boat,strip 6" of insulation off the other ends, solder up those ends and simply drop them into the water. (I''ve done this on my boat).This gives the static electricity a chance to bleed-off thus preventing a streemer thus preventing a strike. But remember, there are no absolute guaranties against a lightning strike.

Dennis L.
03-27-2002 02:51 PM

Get a Dynaplate sintered bronze ground plate. Two 1/4" bolts hold it in the hull, so minimal drilling. The bolts serve as attachment terminals for VHF ground and lightning grounding. I''m not convinced that you can get away from direct strike results. I still let go the helm once in awhile when the flash occurs. A lot of people think there''s some magic bullet for lightning, but "protected" boats that do get hit still get fried.
03-27-2002 01:55 PM

Several years ago I had a similar situation on a Hunt 17 swing keel with outboard. The boat was on a fresh water lake near Ft Worth TX so the lightning issue was major. I ran 1" wide copper as my ground buss for radio, house lights, etc. I kept the buss isolated from everything not using house batteries. Two lengths of 15'' chain (with a large battery type clip at one end) was modified with a piece of #4 copper wire. The copper wire ran nearly the entire length, was soldered to the chain at 1'' intervals and trimmed to make a fine point at the end. I would attach the clips to the shrouds on each side and drop the chains in the water as a storm approached. When possible I would try to get the chains on the bottom (in the mud). Never had a direct strike and never fried any electronics in five years of that kind of sailing. My current boat is setup the way Mr. Casey suggests, however this boat has an auxilary engine, deep fixed keel, galvanic isolator and is in salt water. Hope this helps. Greg
03-26-2002 08:15 PM

Hi, I have a 26'' boat with a swing keel. I have just gutted it out & one of the first things I was going to do was the wiring. I purchased & read Don Casey''s book on wiring a sailboat.
Here is the problem(s).
1. He says to ground your house batteries to the engine so the ground will be in contact with the water through the propeller shaft. I have an outboard that when not in use, does not touch the water.
2. He says for lightning protection you should ground your mast to the keel with a #4 wire. My keel is a swing keel that has the pivot point outside the boat under the waterline, so attaching to the keel is out of the question.

Any advise would be helpfull.
Thanks, Larry C

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

For the best viewing experience please update your browser to Google Chrome