|Topic Review (Newest First)|
|04-01-2011 09:36 PM|
Steve, check this out, he changed his mainsheet.
New dual-speed mainsheet for my boat
|04-01-2011 09:04 PM|
Yes I know RXBOT, but sailingdog posts often and I would like an answer from him.
I believe the original poster went with series 57 harken Carbo, similar to what I want
|04-01-2011 07:17 PM|
|RXBOT||Steve this thread is over 3 years old, would be nice to know how it worked out 4 the original poster.|
|04-01-2011 02:31 PM|
Originally Posted by sailingdog View Post
|10-08-2007 09:42 AM|
Originally Posted by SEMIJim View Post
Good choice...I thought I had mention you get the ratchamatic.
Carbo is good I have a lot of stuff on my boat for Harken.
My boat is mixture of brands...but I decided on that.
I will send you email on main control
|10-08-2007 09:35 AM|
Originally Posted by Giulietta View Post
The bottom block was not in stock at the local place or their distributor, and we were told it'd be 7-10 days. Should be in anywhere from today to next Monday, depending on whether it's closer to the seven days or the ten days, and depending on whether they meant only business days. We're sure hoping it's this week, as we've only three weekends left until haul-out , and the next two are race weekends.
But wanted to give the local business our business and their price was competitive with the most aggressive of the 'net prices.
|10-08-2007 09:27 AM|
'When you moved the mainsheet forward you changed its leverage on the boom. Halfway up the boom would double the sheet tension, all else equal. A few options:
Get a mainsheet with 8 parts (yours is 4). Sheet tension would be back to normal. Maybe you could get away with 6.
Get a small vang and rig it between your becket and mainsheet. You use your old sheet for gross, low-tension adjustment, and the vang for fine, high-tension adjustment. I think Harken sells a complete system like this, but it must be very expensive. A 2-part vang would double the force on the boom, getting you back to your old sheet tension. A 4-part vang would quadruple the tension, so your sheet tension would be half of what it used to be when it was led to the end of the boom. These systems must be clumsy to use.
|10-08-2007 08:43 AM|
what's the deal? Which arrangment did you decide on? Have already tried it?
|10-08-2007 08:39 AM|
I think somebody mentioned that in a mainsheet traveler question in the Learning To Sail" sub-forum. I'm not sure. But thanks for the info. I think I'll paste your comments into a "cheat sheet" file I have, that'll I'll occasionally re-print and keep on the boat.
|10-07-2007 11:42 PM|
I realize that I'm more than a few days late to this party, so I hope this hasn't already been covered.
A few pages back you had a question about "conflicting" advice about sail trim using the traveler. One guy says sheet the sail hard and use the traveler to trim. Another says to ease the sheet and trim with the traveler. Both are actually correct, dependant on wind conditions. Sheeting in hard and trimming with the traveler helps me point a little higher in light wind. Setting the traveler to windward and easing the mainsheet puts twist in the sail in stronger winds. A set of teltails on the leach of the main will tell you how much twist you need. The bottom ones are easy, getting the top one to fly takes a little work.
Good luck with your mainsheet.
|This thread has more than 10 replies. Click here to review the whole thread.|